1Break it, fix it yourself become proficient.
Brad Romesberg posted an answer for this 1997 BMW 5 Series:
"This could be a wheel bearing going bad."
Brad Romesberg
Brad Romesberg posted an answer for this 1998 Dodge Ram 1500 4WD:
"This could be a few things all related to heater core. If fan is stuck or bearings bad if..."
Brad Romesberg
Brad Romesberg posted an answer for this 2002 Honda CR 125 R:
"When you rebuil the top end and pulled the power valve off did you put the screws bacvk in..."
Brad Romesberg
Brad Romesberg posted an answer for this 2005 Honda CRF 100 F:
"run wire from one side bolt to other side and try again if it works coil is bad did you..."
Brad Romesberg
Brad Romesberg posted an answer for this 2003 Yamaha YZ 450 F:
"sounds like bad coil. try runnin wire from one side to the other. If this works you need a..."
Brad Romesberg
Brad Romesberg posted an answer for this 2003 Yamaha DT 125 R:
"does it have oil filter? maybe it needs replaced."
Brad Romesberg
Brad Romesberg posted an answer for this 2001 Harley Davidson XL 1200 S Sportster Sport:
"Check the line where it connects one the other side of the cable from the speedo and where..."
Brad Romesberg
Brad Romesberg posted an answer for this 2001 Yamaha SR 125:
"well to start you need a new engine gasket kit. then take top end off and check rings and..."
Brad Romesberg
Brad Romesberg posted an answer for this 1989 Suzuki Rg 400:
"sounds like your idle adjust needs adjusted. or main needle in carb needs moved up a notch"
Brad Romesberg
Brad Romesberg posted an answer for this 2001 kawasaki KLX 300:
"Sounds like your floats are stickin in the carb. and or one of your lines are in the wrong..."
Brad Romesberg
Brad Romesberg posted an answer for this 2008 Triumph Street triple:
"is this bike air or liquid cooled if air cooled this is normal on a bike to get hotter in..."
Brad Romesberg
Brad Romesberg posted an answer for this 2004 Gas Gas EC 300:
"if it is kicking over easier than before then it needs rebuilt with new piston and rings."
Brad Romesberg
Brad Romesberg posted an answer for this 2004 Skyteam ST 125 Y:
"try changin the plug"
Brad Romesberg
Brad Romesberg posted an answer for this 2002 Kymco Stryker 125:
"ok there is two solutions to this prob to consider first try the clutch cable adjustment...."
Brad Romesberg
Brad Romesberg posted an answer for this 1989 Suzuki RGV 250 K:
"Sometimes changing to carbon reeds is a bad idea if leaning out fuel and using a higher..."
Brad Romesberg
Brad Romesberg posted an answer for this 2001 Hyosung RX 125:
"I think I responded to your question but if not there should be phillips head bolt in the..."
Brad Romesberg
Brad Romesberg posted an answer for this 1998 Gas Gas EC 250:
"try adjusting the idle screw on the carb."
Brad Romesberg
Brad Romesberg posted an answer for this 2003 Suzuki RM 250:
"try adjusting the needle jet on the top of the carb down one setting this will raise the..."
Brad Romesberg
Brad Romesberg posted an answer for this 2002 Husqvarna TE 400:
"That sounds like a float problem. When you tip it back it is raising the floats letting..."
Brad Romesberg
Brad Romesberg posted an answer for this 2002 Moto Guzzi California 1100 EV:
"this means your carb is set to rich fuel to air mixture is wrong. If this is single..."
Brad Romesberg
Brad Romesberg posted an answer for this 2003 Yamaha YZ 125:
"you dont need pictorial for clutch. After you take the case off there should be like 5..."
Brad Romesberg
Brad Romesberg posted an answer for this 2004 Honda CRF 150 F:
"Not positive but on two stroke bikes all but one of your hoses are breather and over flow..."
Brad Romesberg
Brad Romesberg posted an answer for this 1987 Honda XR 250 R:
"sounds like you got the air filter casing backwards"
Brad Romesberg
Brad Romesberg posted an answer for this 1977 kawasaki KE 125:
"Being that this bike is vintage. You prob have points if not then you have a magneto and..."
Brad Romesberg
Brad Romesberg posted an answer for this 1995 kawasaki KLE 500:
"yes you are going to need a technical manual with the gauged settings of the factory. This..."
Brad Romesberg
Brad Romesberg posted an answer for this 1998 kawasaki ZX-6R Ninja:
"are you sure it is not the carburateur gasket leaking if it was rebuilt they removed the..."
Brad Romesberg
Brad Romesberg posted an answer for this 2004 Yamaha YZ 250 F:
"My best advice is coming from home mechanics. I work on my own bikes. I suggest getting on..."
Brad Romesberg
Brad Romesberg posted an answer for this 1998 Jeep Cherokee:
"there is one under the hood in the fuse assembly. Check your owners manual and see which..."
Brad Romesberg
Motorcycles 25 answers
Cars & Trucks 3 answers
