Brave and bold
Randy Herring posted an answer for this Altec Lansing Multimedia Computer Speakers:
"the subwoofer plugs into the wall on a 110 volt outlet. then use mastervolume control.. ..."
Randy Herring posted an answer for this Pyle PD3000A Amplifier:
"IT DOES NOT LOOK LIKE THE RECIEVER HAS A OPTICAL INPUT YOU WILL HAVE TO USE AV CABLE STERO..."
Randy Herring posted an answer for this Audio Players & Recorders:
"use a hdmi cable for audio and video"
Randy Herring posted an answer for this Pioneer Audio Players & Recorders:
"powered sub should work no mater what your listing to unless its not set up"
Randy Herring posted an answer for this Technics Audio Players & Recorders:
"amp must have a phono input use it if it still has low volume you will need a preamp.radio..."
Randy Herring posted an answer for this ElectroVoice http://www.electrovoice.com/products/70.html Amplifier:
"you shuold have used a power converter a transformer may not work as you also have a..."
Randy Herring posted an answer for this Audio Players & Recorders:
"Then only use the cd input for your output you may have to swap input wires from different..."
Randy Herring posted an answer for this Audio Players & Recorders:
"Helo again Well how about a newer onkyo stereo or a 5.1 channel surround sound.all are..."
Randy Herring posted an answer for this Sonance Sonamp 260 MKII 2-Channel Amplifier:
"Tape out from dennon to tape in on sonamp then select source from dennon. GOD LUCK BIGRED"
Randy Herring posted an answer for this Audio Players & Recorders:
"Bass Treble,bal controls can be clened with contact cleaner. Drive belts audio heads may..."
Randy Herring posted an answer for this Audio Players & Recorders:
"Could be the speaker output relays. GOOD LUCK BIGRED"
Randy Herring posted an answer for this Audio Players & Recorders:
"18years is good service you may want to look at upgrading to a newer model. If you have..."
Randy Herring posted an answer for this Audio Players & Recorders:
"this outdated system,but a regular rca cable will inter connect the components.as or the..."
Randy Herring posted an answer for this Yamaha P2500S Amplifier:
"Protect delay is in the relay and not adjustable as to delay time. I would not worry..."
Randy Herring posted an answer for this Audio Players & Recorders:
"Does your rca cables go to a surrond sound amplifier or directly to the tv. The tv only..."
Randy Herring posted an answer for this Marantz MM9000 5-Channel Amplifier:
"The main power transformer may not have the correct voltages coming out of it. I would..."
Randy Herring posted an answer for this Audio Players & Recorders:
"More than likely the final amp chip needs replaced,and or may be a cold solder joint on..."
Randy Herring posted an answer for this Onkyo TX-SR674S 7.1 Channel Up-Converting A/V Receiver Amplifier:
"Is power coming out of transformer at the right voltage. Also may have a power i.c...."
Randy Herring posted an answer for this Myryad M Series MDP 500 7.1-Channel Amplifier:
"Check the repair dirctory at the bottom of this site"
Randy Herring posted an answer for this Kramer 903 2-Channel Amplifier:
"Try mcm electronics."
Randy Herring posted an answer for this Pyramid XPA200 Amplifier:
"Make shure your wall socket is grounded.Pull cover and look for black and wite and green..."
Randy Herring posted an answer for this Marantz PM7200 2-Channel Amplifier:
"Pull cover check for fuses on the bord and replace with exact rating on the fuse."
Randy Herring posted an answer for this NAD T973 Amplifier:
"Pull bottom panel and get some canned air and spray around circuit board .May have a..."
Randy Herring posted an answer for this Myryad M Series MA 500 Amplifier:
"Try the repair directory on this site"
Randy Herring posted an answer for this NAD C320 2-Channel Amplifier:
"May be dirty lens get a cleaning disc for cd player and insert to clean then try player..."
Randy Herring posted an answer for this NAD C372 Amplifier:
"Unplug for 20 min. and then plug in to try and see if it will come back on."
Randy Herring posted an answer for this Audio Players & Recorders:
"You must feed the amp with stereo imput then adjust amp for pro logic and activate all..."
Randy Herring posted an answer for this Sony TA-N9000ES 5-Channel Amplifier:
"Check windings on input and output of main power transformer.Make shure no open..."
Randy Herring posted an answer for this Crown CE1000 2-Channel Amplifier:
"Cuold be the final power amp ic. Might be imput transistors to that channel. Its possible..."
Randy Herring posted an answer for this Yamaha DSP-A3090 7-Channel Amplifier:
"The power amp does need an imput signal ie. tuner, cd , and such to play. You can use the..."
Randy Herring posted an answer for this Teac A-1D 2-Channel Amplifier:
"It depends on what parts. Most parts can be generic replacenents some such as power..."