Zmodo troubleshooting
Sound like someone turned off the focus asst light in the the menu of the camera, Need to turn it back on.
9/7/2014 12:45:09 AM •
Zmodo...
•
406 views • 0 helpful votes
Not recording
might be your hard drive that is faulty. try to format it and see what happens.
IR light doesn't work on security camera.
nitevision is in monochrome.. but if the irs dont work in that camera need to either get an ir light for that unit or replace that specific camera..the ir board is burnt out..or disconnected..I have several systems in use at different locations and I do installs for residential locations..I get some of my units off ebay..
1/20/2014 5:31:23 PM •
Zmodo...
•
156 views • 0 helpful votes
How to hook up audio
Connect a microphone and enable the audio. It should all be in the settings. Check each camera to make sure audio is enabled. Usually it is off by default.
6/24/2013 6:35:54 AM •
Zmodo...
•
534 views • 0 helpful votes
How to hookup audio to home security sys
do you have audio cameras, they don't usually give you the audio cameras with a standard setup, on the back of the dvr there is a plug for audio its either a phono plug or a mic input socket, this can be used in one room or outside depending on the mic you have to buy. you then wire this up to the cctv and have to setup the sound to the camara number.
6/24/2013 7:19:32 AM •
Zmodo...
•
452 views • 1 helpful votes
Alarm chirping
have to turn off all your alarm settings and motion settings to stop the chirp. the chirp is the motion alarm.
H9124v VGA Reset
Default 4 Digit user code: 1234 or 0000Default 6 Digit Security code: 123456 or 000000Type *#06# at the mobile screen to know IMEI no of your mobile.send the IMEI no to me and i will reply you with unlocking code.IF Problem not Solved SoPlease New Software install in the Phone Problem will Solved
Not finding what you are looking for?