Zanussi Dishwashers - Page 8 - Recent Questions, Troubleshooting & Support
MY DISHWASHER WONT START ITS CYCLE THERE IS VIBRATION IN THE BOTTOM AND NO WATER ENTERING
The vibration is probably the electric valve that opens and closes the water supply valve on the dishwasher underside. If you have set a few dishwashers before, you may be able to remove yours to access the solenoid valve on the bottom of your dishwasher and replace this part for a few bucks, then reset the dishwasher and test. The buzz/no water symptom points directly to this part being your problem. DO NOT work on your dishwasher without some previous knowledge of dishwashers in general. The electrical power must be shut off/unplugged, the water supply must be shut off and the drain hose must be disconnected before removal and repair. Be careful and good luck.
2/17/2015 9:24:04 AM •
Zanussi...
•
Answered
on Feb 17, 2015
Zanussi diswasher ZDI6053N does not finish its cycle.It has to be turned off manually
Your dishwasher is a sophisticated device that registered most failures. The End of cycle LED flashes if there are alarms memorized. So, count how many times the End of cycle LED flashes.
For example:
One flash - i10, the problem with water intake
Two flashes - i20, a problem wit drain water
Three flashes - i30, activated anti-flooding device
..... and so on
Dado
1/9/2015 10:11:56 PM •
Zanussi...
•
Answered
on Jan 09, 2015
Zanussi zsf2440 overfilling
The pressure switch controls the water level.
Without water, contact is closed.
In addition to checking the electrical correctness the pressure switch and check the tightness of the hydraulic circuit of pressure switch.
Dado
1/6/2015 10:15:19 AM •
Zanussi...
•
Answered
on Jan 06, 2015
Why is our zsf6128 dishwasher is stuck in dry mode and cannot start it
I'll try to explain how drying works generally in the dishwasher.
Dishes absorbs heat and cools more slowly than a very thin wall of stainless steel.
The consequence is that water evaporates and in accordance with the Mollier diagram begins to condense on the walls of the stainless steel whose temperature is lower due to faster cooling of the dishes.
Now drying can be divided into two categories. Active and passive.
Passive way of drying the natural circulation of moist air and condensation in the condenser, which is usually located on the left or right side of the dishwasher.
Active way of drying works on the principle of forced circulation humid air with fun helping quickly condenses and thus speeds up the drying of dishes.
In passive mode the drying process can speed up the partial opening of the door.
Dado
1/6/2015 9:56:28 AM •
Zanussi...
•
Answered
on Jan 06, 2015
Cycle takes forever also not heating
On the side of the units there is a matrix (up and down tubes ) they need cleaning but I will warn you the pipes from the drain and through the matrix are gummed up with a disgusting sludge. There are some push on fittings and some held with spring clips take some photos when disassembling but it is easy just time consuming trying to flush the gunk
Not finding what you are looking for?