Zanussi Dishwashers - Page 6 - Recent Questions, Troubleshooting & Support

"3 in 1" function This appliance is equipped with the "3 in 1" function, that allows the use of the "3 in 1" combi detergent tablets. This function can be selected with all washing programmes. With the selection of this function the inflow of rinse aid and salt from each respective supply container is automatically deactivated and also the indicator lights for salt and rinse aid are deactivated. Select the "3 in 1" function before the set of a washing programme. Once this option is selected (indicator light illuminated) it will remain active also for the following washing programmes. With the use of the "3 in 1" function, the cycle durations may change. In this case, in the digital display, the indication of the running time of the programme is automatically updated. NOTE: Once the programme is running, the "3 in 1" function can NO longer be changed. If you want to exclude the "3 in 1" function you have to cancel the programme setting (see chapter "Starting a washing programme" - "Cancel a washing programme in progress") and then deactivate the "3 in 1" function. In this case you have to set a washing programme (and options) again. Activation/deactivation of the "3 in 1" function (The dishwasher must be switched off) 1. Press the On/Off button. The On/Off indicator light illuminates (setting mode).If a programme button indicator light is on, this means that a washing programme is set. The programme must be cancelled: press simultaneously function buttons 2 and 3 for about 2 seconds. All the indicator lights will turn off (except for the On/Off indicator light and eventually salt and rinse aid indicator lights) indicating that the set programme has been cancelled and the machine is now in setting mode. 2. Press simultaneously function buttons 2 and 3, until the indicator lights of function buttons 1, 2, 3 and 4 start flashing. 3. Press function button 4, the indicator lights of function buttons 1, 2 and 3 turn off while the indicator light of function button 4 goes on flashing. 4. Press function button 4 again, the "3 in 1" indicator light illuminates, indicating that the "3 in 1" function is active. To deactivate the function press function button 4 again, the indicator light turns off. 5. To memorise the operation, switch off the dishwasher by pressing the On/Off button or wait about 60 seconds after which the dishwasher will automatically return to setting mode. Dado

C8 error code

I would think the control PCB is defective.

The timer box is located in the compressor compartment to connect the timer to the electrical components which defrost the battery evaporator (defrosting heater, thermal switches). Dado

Hi, it sounds like the fridge thermostat needs replacing.

errore e3?

Model number needed. PNC number

i40 Alarm Code - family : Analogue pressure sensor problem. Dado

C8 - During rinse phase boiler doesn't empty:

• Rinse pump not efficient.
• Rinse arms obstructed.

• Boiler level sensor out of order.

Dado

Dishwashers are suppose to be hooked up to hot water. If you had hotter water it would clean just fine. 120 deg or more!

If you have a Zanussi clothes dryer, I can only give you generic information. Here goes. In the US, clothes dryers will not heat for 3 reasons, normally: 1) The heating element has failed, usually the heating coil has burned in two. It will need replacement. 2) One of the thermostats or the fuse has failed, and must be replaced. The fuse and the thermostats ( there are up to about 5 on newer machines) are there to prevent the machine catching fire should it overheat. 3) One of the wires inside the machine has burned in two, or has broken inside the machine. God bless your efforts.