Yukon Sport & Outdoor - Others - Page 9 - Recent Questions, Troubleshooting & Support
How to clean dirt off your skateboard deck
I also have a hoverboard which was ordered from "Betterscooter"
Here are some steps that you may follow:
- Remove the wheels.
- Free bearings from your wheels
- Clean off major dirt and grime
- Pop off the bearing shield caps.
- Soak your bearings in your solvent from solvent
- Remove and dry your bearings
- Accelerate drying
I hae a Pro Form
Hi,
I will advice you try re-calibrate your treadmill, follow the procedure below to re-calibrate it,
Step 1
Stand on the side rails of the treadmill for safety purposes. Remove the safety key.
Step 2 Press and hold the two
incline buttons. The incline buttons are blue and on the left side of
the display. Hold the up and down button simultaneously. Release the
buttons when the display reads "Calibration."
Step 3 Press the green start
button located either above or below the large, red stop button
(depending on your model). Stay on the side rails as the treadmill belt
begins to move. Both the speed and incline should go through their full
range from lowest to highest, and then back down again.
Step 4 Repeat the process if the
display does not read "Calibration Successful."
HOW TO PUT A TENT UP
Hi I have the full instructions for pitching the Lichfield Condor Family Dome tent with 2 bedrooms if anyone wants a copy happy to email it :)
Error code nFL?
Do you have any idea what this error code could possibly be in relation to, because I have totally no idea whatsoever!!!!!
I have an old Wenzel
I have copies of the 34348 and 34349 instructions. Post your email address and I can send to you.
Need to re attach the
Go to the hardware store and they sell a cable u bolt. It has nuts on both ends. You put the cable through and double it back through and tighten both nuts.
Not finding what you are looking for?