York Tools & Hardware - Others - Recent Questions, Troubleshooting & Support
Airquest dc90 has erratic burner operation, it
-
sounds like the control board. i cannot confirm this as i am not able to come sit in front of your furnace. please have a tech come to sit in front of your furnace and figure it out!!
Gas furnace
Hi check out the pressure switch clean the air filter and check out the fan control see if this is clean
York furnace .induced draft motor runs when t stat is off
Sounds like a bad thermostat or stuck motor control relay. Turn off the breaker at the unit or in the electrical panel to kill the motor and see if cutting power, if relay is bad, cycles off and stays, but you should leave power off and call for service right away.
Where is the switch to the furnace to shut blower off?
There is a switch, activated when you open the service panel, that kills most power to the unit, including the DI Blower motor. Your furnace should also be equipped with an exterior kill switch, or there's always the good old breaker box. Good Luck!
Draft inducing blower motor for york stellar plus
Check the relay for that motor. Follow the wires back to locate the relay. If the relay clicks when you advance the thermostat then check the relay contacts with a multimeter. If there is continuity and a low resistance value on the contacts then look at the motor itself. There is a hi limit safety klixon switch that may be holding voltage from reaching the motor too. The wiring diagram should be on or inside an access panel.
Gas central heater
The "mother board" or integrated control module is essentially the brain that controls the sequence of operation in your gas fired furnace. It is located, generally, in the blower compartment. That is the bottom of the two compartments of the in the furnace. It looks like a circuit board with all the wires of the furnace leading to it.
York 92 % eff. furnace shuts down on # 3 error (pressure switch)
i have fixed almost every one of pc9 -----we have installed in our company,code three{flashes} at first new presure switches installed, same thing,york knows about this,induction motor bearings,could be bad.our local york dist, has boards,inducer, ***.motor, dual press.switch,free.as is known as the only way to fix.after all else is ruled out.one local competator called us if we wanted to join class action suit . good luck.furnaces work good at first, season or two then bam
Not finding what you are looking for?