Yes Televison & Video - Popular Questions, Answers, Tips & Manuals


You aren't going to like this answer - a HDTV does not need a special antenna to receive transmissions. It should work regardless of what TV/antenna combo you have.

Yes Televison &... | 45 views | 0 helpful votes


Back - light problem. Check and replace damaged component/s at its back-light inverter board, or replace this board as card basis. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. It will be best to replace the inverter board as card basis.
http://electronicshelponline.blogspot.com/
To some model sets; especially LED back-lighted types; the back-light inverter circuit will be part of the main power supply board [SMPS]. In such cases, the power supply board might need replacement. To some models sets, the back-light inverter and SMPS section circuit will be integrated at its main board itself. If so; the main board should be replaced. To some models of sets, all these section circuit will be integrated at its main board. If this is the case, you have to replace the main board.
Search the site by type in the "brand name" to your device; [Exclude the model number], in the "Search box at the top right of the display window of the Homepage" to get gathered related posts./

Yes Televison &... | 34 views | 0 helpful votes


Without a remote control, you can't. If you wish to buy its original remote control, contact the authorized service centre, or authorized dealer to your device brand. They can either give you a genuine remote control to your device, or can direct you, from where can you purchase a suitable one.
To select a proper universal remote control, you should know about the number of digits to its set-up codes. There are 3 digit, 4 digit, 5 digit, 2 digit and even single digit codes, to some brand devices. After confirming this, check the sites linked here. Both the sites have set-up code list and set-up procedure to many popular brand remote controls. Check which brand remote control has set-up code/s to your device brand, and buy that one according to availability. Brand name of the remote control isn't a matter, but it should have set-up codes in its code list, to the device brand you have.
Please note: Every new universal remote control will have set-up code list, and set-up procedure along with its pack. Never accept a remote control, that hasn't both of this. For more details about the set-up codes, visit the sites.
https://homenol.blogspot.com/
https://electrohelponline.blogspot.com/
https://remotesearch.blogspot.com/

Yes Televison &... | 62 views | 1 helpful votes


A cable converter box will not work that's why when high def cable came into effect people traded their boxes into the cable company but you can go to Walmart and look at the antenna screw into the cable they run anywhere from $25 to a hundred my ex-wife got one at dirt cheap is $75 1 for 25 bucks gave her six channels

Yes Televison &... | 25 views | 0 helpful votes


Please explain what you are talking about; Make, model and component number.

Yes Televison &... | 30 views | 0 helpful votes


no you dont bud
Have a flying time!

Yes Televison &... | 29 views | 0 helpful votes


Do not post a new question, use the email link to answer. The player has failed, best route just replace it.

Yes Televison &... | 27 views | 0 helpful votes


Clean the disk drive if possible.

I've had many a problem with DVD players saying "No Disc". It can be any number of things. On my portable DVD player, some of the problems were traced to one of the following:
  • The DVD is not properly set in the cradle,
  • The battery power left in the rechargeable batteries was not strong enough and needed to be replaced,
  • The Lens needed to be cleaned on the player.
I've had two DVD players stop working in this way, but never figured out why because the repair cost was much more than to just buy a new player.

There is a similar problem at this site:


Will not play dvd says reading disk then no disk

Yes Televison &... | 50 views | 0 helpful votes


go to your color in settings on remote and turn the brightness up a notch not to much just a notch.

Yes PDV-102CRT... | 56 views | 0 helpful votes


Usually suspect condensation problem, let it dry out and try cd first.White screen maybe contact resistance in the connector due to condensation from room humidity.

Yes PDV-102CRT... | 92 views | 0 helpful votes


...be sure you are in the same zone as the DVD was designed for. The world seems to be divided in numerous zones, and DVD'S from one area will not work from another area. That is why one should not buy equipment when one goes on vacations !

Yes PDV91 9 in... | 107 views | 0 helpful votes


This unit comes with a remote control Use the remote to change the screen option and hide the elapsed time.

Yes PDV-102CRT... | 120 views | 0 helpful votes


Your TV is "going off" because the power supply is failing.

Televison &... | 140 views | 1 helpful votes

Not finding what you are looking for?
Yes Logo

35 questions posted

Ask a Question

Usually answered in minutes!

Top Yes Televison & Video Experts

Marvin
Marvin

Level 3 Expert

84625 Answers

NOEL
NOEL

Level 3 Expert

8503 Answers

ray gallant
ray gallant

Level 3 Expert

63044 Answers

Are you a Yes Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...