19hp yardman riding mower
Hi Lisa:
If it won't shut off then the ignition is on all the time.
If the start switch won't spin the starter, then the switch is not working.
Something happened to cause this problem.
Who did what to the wires? or
It did it all by itself in which case the switch needs to be replaced.
I would use a continuity meter to check the function of the switch and make sure the wires are correctly connected.
Hope this helps.
CAN THE PULL ROPE BE REPLACED?
Yes.
It's a matter of dis-assembly, replace, and re-assemble.
You should be able to get thae part (and the work done) at any local small tool rental or service shop.
BRAND NEW TILLER WIRE HANGING DOWN BY CARBUREATOR BOWL WHERE DOES IT GO.
David try this there should be a piece of flat metal that is horizontal by the carb. bowl that you can push back and forth, it should have a hole in it. The end of that wire should go into that hole and you need to crimp that wire so that it stays in the hole attached to that piece I described that moves horizontally. Based by the picture of your tiller this wire is going control your throttle so that your tines turn.
Briggs & stratton intek 17.5hp smoking
check the oil see if it smells like gas if so the carb is not sealing over filling and draining into the oil a new carb can go bad or ts gas from the bad old one
Crazy question but where is
The primer button is usually on the carburator of your machine. Most of the time on the side of the carburator , but sometimes on the front of the carburator. GOOD LUCK.
Not finding what you are looking for?