Yamaha RS Vector - Popular Questions, Answers, Tips & Manuals
Engine cuts out and wont go past 35
There are a few items it could be.
(a) Low Compression
(b) Blocked High Speed Jets (Clean them with a Wire)
(c) Blockage in the Fuel Delivery System
(d) Lack of Oil
Don't have very much power in my yamaha vector 1000
If you have never rebuilt a Carburator, there are some VERY SMALL ORIFICES that need to be cleaned and require a very small wire to get them cleaned.. You may also have a Compression Issue with the engine, a Bad/Defective Primary Clutch could also cause a drag on the Engine
How to remove a gas tank on Yamaha Apex 2007
You have to remove the 2 bolts holding the seat down under the tunnel first. Then slide the seat to the rear to remove it.
Then you can remove the springs holding the hold-down plate on the rear of the tank. Just slide the tank back then.
Engine icon flashing and motor running rough
Well on modern cars there is an egr, exhaust gas recirculation, when this clog up, which often happen if you just do urban especially short trips to the shops or school runs,, the computer stop you going above certain speeds, and it runs rough, or the mass airflow meter pack up, if you are mechanically minded you can replace or clean out the egr, if it's the mass air flow most likely you'll be buying another,
Hope this was of use
Vic
Not finding what you are looking for?