Install model # xvp620 phone on windows 7
The Vendor's site appears to be under construction, and I don't see any Drivers or "Help" there. Maybe this is why no one has responded. Sometimes there are no new drivers for old technology, but I wish you luck.
6/2/2014 8:30:13 PM •
Xact...
•
225 views • 1 helpful votes
We need a battery XB 12
Do a search on eBAY. There are lots of second source batteries there and they seem to be decent quality. I have bought many for all sorts of devices from these venders.
5/6/2014 1:41:46 AM •
Xact...
•
94 views • 0 helpful votes
Manual xg2801
EL SEGUNDO AURICULAR NO ME DA TONO DE LINEA ME MANDA UN MENSAJE EN PANTALLA DE "BORRAR" COMO ACTIVO EL SEGUNDO TELEFONO ....URGE
1/22/2014 8:06:38 PM •
Xact...
•
204 views • 0 helpful votes
Hello, where can I get wall charger for Xact x2x
your device should be marked with polarity and voltage requirements. Any power supply with the correct plug meeting those specs (if amperage isn't marked, look for one that is between 500- 1000 mA) should be fine. MAKE SURE it is a DC supply if the device you are using is marked DC.
10/22/2013 1:55:44 PM •
Xact...
•
211 views • 0 helpful votes
How to get rid from continuous hissing sound of
Many times the hissing can be caused by a bad or poorly charged battery, or by activating an interference eliminator code in all your radios. First, we would suggest changing the battery, or exchanging it with a known good radio's battery to see if the problem clears up. Environmental RF can also cause issues, so you might check to see if the same problem exists in a different location.
If these suggestions do not solve the problem, then you possibly have an internal issue which would deem the radio non-repairable. Parts and schematics were never offered for this line of radios.
Best regards.
10/15/2013 7:35:07 PM •
Xact...
•
97 views • 1 helpful votes
My xact boombox just stops
Thanks to all of you for your detailed comments I found an easy way to repair the boom box. Many of you said that if you pushed down on the radio hard it would play so I tried it and I too had the same problem, but since it is impossible to stand all day holding the radio and get anything else done I figured if you can't lower the radio raise the plug! Here is what I did, first unplug the radio so you don't short anything out, then at the front of the plastic plate the radio plugs into gently pry it up with a lock blade knife (as a rule kitchen knives are too flexible) then get a small self tapping screw (the smaller the better) and screw it into the gap made by the knifeyour radio will now play without holding it
3/26/2013 9:05:00 PM •
Xact...
•
86 views • 0 helpful votes
Where do I buy a
http://tekgems.com/Products/et-9686-con-x3x-n.htm
8/31/2011 3:18:15 PM •
Xact...
•
112 views • 0 helpful votes
Metal prongs on the antenna
There are a couple of different ways the antenna connection can break. Docks and antenna replacements are available, though the actual prong itself may be difficult to track down.
6/15/2011 2:06:20 PM •
Xact...
•
138 views • 0 helpful votes
HOW DO YOU TURN ON
First make sure it is charged then press and hold the power swich for about 2~3 seconds do not let go right away as the first of power up will put you in the time set /program mode.
Hutch
1/27/2011 6:58:58 AM •
Xact...
•
105 views • 0 helpful votes
I have idectx1i twins cordless
make sure you are using the line cord that came in the box with the telephone as this won't work with a different telephone's cord.
Is there a trident symbol flashing in top left corner? if so, press menu, down to setting, press ok, down to handset setting, press ok, down to register, press ok, enter pin 0000, press ok and at the same time press and hold the handset locator button on the base station for 10 seconds.
1/4/2011 3:15:29 PM •
Xact...
•
60 views • 0 helpful votes
Not finding what you are looking for?