I need the stringing instructions for a Wilson
You can usually search data bases, like https://klipperusa.com/pages/racquet-stringing-patterns. If you are familiar with stringing terminology. If you have been stringing tennis rackets as long as I have (+20 yrs). You can figure it out without stringing patterns.As for the string pattern found on the Klippermate website.Tension 55 - 65, String length 20'M - 18'C, Pattern 16M X 19C, Skip M Holes 7,9T - 7,9B,Tie off M 6B, Start C 7T, Tie off C 5T - 11B
Lost manual need to set time
I cannot set the digital time on my new watch after multiple attempts using the instruction diagram. Nothing moves the time at all. How do I set the digital time?
Setting SWR Wilson 5000 magnetic mount antenna.
Your antenna is probably still to long. You need to do a few things to see if your antenna is too long or too short. Here is a link to something I found that is very informative, and a post on how to do what you need to do. there is also a thread on the site that has common problems for high swr.
http://cbmx.org/forum/showthread.php?t=8
here is common problems for SWR
http://cbmx.org/forum/showthread.php?t=46
Start with the first article.
Setting SWR
hi ken, SWR has nothing to do with your power supply, Standing wave ratio, It is the amount of power which is reflected back to the radio when transmitting, If you have a SWR of 10 or over on a wilson 5000 I would imagine you have a short in your feed line[coax].
I would replace the pl259 connector and check the coax for damage.
Paul,.
9/21/2009 9:36:03 PM •
Wilson...
•
119 views • 1 helpful votes
Crown of Titan 9G1 watch purchased 1998 needs replacement -
Hello there:
if you are in the sydney or the melbourn or pearth area there are several watch dealers avaiable for you just look up the watch maker and the model of the watch and look for local dealer ok ?
best regards michael
USN RETIRED
Cell phone reception dead after using amplifier
I had this same problem with a motorola razr some time back. Some cell phones have a built in switch (such as the Razr) inside the external antenna connection. In the case with my razr, I
evidently pushed the adapter into the phone too far. I later had to jump out the switch inside the
phone to make it work with it's internal antenna again. Unfortunately, I could'nt use that same phone with my amp again. Just a thought on your problem.
12/1/2008 5:14:14 PM •
Wilson...
•
179 views • 0 helpful votes
Not finding what you are looking for?