Whirlpool duet - Recent Questions, Troubleshooting & Support - Page 6
F11 error code on whirlpool HE3
Water up to door level means your motor and motor control unit (MCU) was covered with water. Most likely your Motor control unit (MCU) is damaged rather than Central Control Unit (CCU).
Listen, you have to buy a new machine. If you end up putting CCU and MCU both into a soaked wash motor washing machine, you will be so mad with yourself.
Time to go to Home Depot looking for a new machine.
You use that flooded machine then all your washing machine warranty and liabilities from the manufacturer is out of the door. Even your home insurance may not honor if you knowningly use a flooded machine and something goes wrong.
Whirlpool duet WFW9600TA00 f35 error
F35 error code is indicating a problem with the water level pressure switch operation (key#20). There could be a blockage in the air dome or pressure switch hose (key#21). The air dome is located on the back of the tub on the left hand side
SUD means the washer has detected suds, or foam inside the basket. Suds will cause the washer to wash poorly, and it can lead to other issues. The first step is to confirm you are using H-E detergent. H-E detergent is formulated to get your clothes clean with less water, and without creating foam
F25 is a DRIVE MOTOR TACHOMETER ERROR. This error is one of the toughest one since it really does not narrow it down. I would do plenty of testing before replacing the expensive parts. If the control is unable to properly detect motor speed, the machine shuts down.
If a failure occurs during high-speed spin, the door unlocks after 3 Minutes.
Possible Causes/Procedure
1. Verify the shipping system including shipping bolts, spacers and the power cord are removed.
2. Unplug washer or disconnect power.
3. Check drive motor tachometer resistance. It should be approx. 115 ohms.
4. Check wire harness connections between the drive motor and the Motor Control Unit (MCU), and between the MCU and the Central Control Unit (CCU).
5. Plug in washer or reconnect power.
6. Check the MCU by looking for operations of the drive motor.
7. Check the drive motor for powered rotations.
If everything checks out okay, you should think about replacing the MCU since it may not read your motor correctly.
Whirlpool front load washer model WFW9050XW00 -
Your pump is jammed with a blockage, remove the filter and check the pump behind it is revolving, usually a hair grip or button in there...remember the washer is full of water so you will have a lot of water coming out
Not finding what you are looking for?