Whirlpool Cabrio - Recent Questions, Troubleshooting & Support - Page 6

The pump does make a ratcheting noise, http://www.appliancepartspros.com/pump-parts-for-whirlpool-wtw6600sw2.html

Could be a bad stator http://www.appliancepartspros.com/motor-basket-tub-parts-for-whirlpool-wtw6200sw0.html

Its a bad solenoid http://www.appliancepartspros.com/control-panel-parts-for-whirlpool-wtw6600sw2.html

Check that all the many wire connector plugs are seated correctly on the board

Your model has a bearing under the tub which is probably going bad and needs to be replaced. cabrio washer bearing replacement YouTube

Sounds like a bad main board , Good thing its new under warranty

remove about 6 or so screws on the back (top) then slide the top forward about a 1/2 inch then lift.

Check out this video https://www.youtube.com/watch?v=8KPp2l8SM1Y

Check your suspension supports, when empty move the tub around it should re-center with force like it fights you to be in the center,

The start switch is an integral part of the control panel main board.

Make sure that the water is turned on. Carefully under the main control panel if you lift it up when the water should be on you should hear the water inlet solenoids clicking on then off, if not make sure that the wires are connected UNPLUG FIRST BEFORE TOUCHING ANY WIRES

Remove about 6 or so screws on the back (top) then slide the top forward about a 1/2 inch then lift.

Not recomended

You need to use HE soap and the right amount criticle with HE washers.

Could be that you need a new lid lock. Chech to see that your floor under the machine is completely dry.Sometimes wet componets can cause false codes

The pump when going sounds like a grinding noise

Assuming that you have the hoses connected and the water turned on.it could be the water inlet solenoids

On the bottom you can see it by just tipping the washer , its a stand alone unit it can fit in the palm of your hand. Simple to take out 2 screws and two wire connectors. UNPLUG FIRST

Too much soap

Raise the top cover and look on the inside of the front panel, it should be taped on there/