Whirlpool Cabrio - Recent Questions, Troubleshooting & Support - Page 5

Some models you can get them, on some models you would need the whole main board. You might be able to go inside and find out if it can be tightened

Yes but check your model no. to be sure http://www.appliancepartspros.com/top-cabinet

Check to see if there is water on the floor , I had similar problem I traced it to my tub leaking onto the shifter which gave me false codes going off

Make sure you use liquid soap with HE on it And you can buy a cleaner to wash your washer on a regular wash cycle

Your drain hose has to be higher than the water level in the tub, almost up to the top of the tub

No its linked to the main board. Well if you were an Electrical PLC engineer, maybe

Chattering could be a shaft bearing and if it got bad enough could have damaged the tub seal and makes it leak. attached is a price on parts if your interested http://www.appliancepartspros.com/07-tub-parts-for-admiral-aav7000aww.html

yes my wife does it all the time

It sounds like your inlet vales are leaking. They are located on the top. Parts for Whirlpool WTW6600SW2 Control Panel Parts

Attached is a video on removeing the tub https://youtu.be/6QOxVodC59Y

You most likely need a new tub seal, but check your hoses and pump first http://www.appliancepartspros.com/motor-basket-tub-parts-for-whirlpool-wtw7600xw2.html

Yes this is a common problem

You have a hot , cold and a mix valve ,I would suspect that the mix valve is stuck, try tapping on it Whirlpool W10372095 Valve AppliancePartsPros com

I think it could be your main board, but first open it up and check the many connectors to ensure that are seated correctly. UNPLUG THE MACHINE BEFORE SERVICEING http://www.appliancepartspros.com/parts-for-whirlpool-wtw5550xw0.html

The bearing is probably going bad, spin it with your hand if it makes noise or you feel a vibration its bad Parts for Whirlpool WTW6600SW2 Motor Basket and Tub Parts

There is a spin sensor that is part of the shifter if this is wet it wont sense the spinning, hence wont spin, and if it is wet you mat need to replace the tub seal http://www.appliancepartspros.com/gearcase-motor-pump-parts-for-whirlpool-wtw5600xw0.html

Lift off the top cover and make sure that the supports are connected http://www.appliancepartspros.com/top-cabinet-parts-for-whirlpool-wtw6600sw2.html

If you hear the pump running then it is probably clogged, you can remove it and visually inspect it, if you don't hear it running check that there aren't any loose wires on the pump else the pump could be shot. ALWAYS UNPLUG BEFORE SERVICEING