Whirlpool Ovens - Page 8 - Recent Questions, Troubleshooting & Support

According to service manual F03 is faulty control unit http://www.fixya.com/support/t27082170-whirlpool_oven_akz430_goes_f03_mode_in

Hi

Code F03 usually means that the oven temperature sensor is 'open circuit', that is not working at all.

The remedy is to have it replaced.

Needs programming sometimes they leave the factory without it or they can lose the programme.

Hi


Thanks for using FixYa. F3 error means Open oven temperature sensor or thermal fuse. You’ll need to replace oven temperature sensor or thermal fuse to resolve the issue.


Please do accept the solution if the issue is resolved or else revert for further assistance.


Thanks
Rylee

I bought a new oven found this one way to complex anyway. Afterall i just want to cook in it.

Regards

Ken Mc

What is error code F134 on Zanussi combi microwave ZKC44500XA

You may have a damaged oven control panel. Contact your local utility and file a damage claim

The likely problem is that the oven control panel is burned out.

Fix it because it need repair

Go to this link on the ukwhitegoods forum http://www.ukwhitegoods.co.uk/forumsphpbb3/cooker-oven-forum/switch-whirlpool-generation-2000-oven-t35121.html

These answers are not a solution to the problem!!!!

This may be due to a partially shorted heating element.

check to see if there is a fuse needs to be replaced any new models or exact same model shud be purchased here>> Procellular Services News Reviews and Deals Online

does it flash or light up if not have the clock by passed and it will go again

dont you mean temp is to low ? First thing is make sure you dont have the temp setting to high the larger the number the colder it gets,note if turned down it will take 24 to 48 hrs to notice any difference. If good then most likely a faulty thermostat

with the on switch for the oven the higher the numbers the hotter the oven the thermostat will do the controlling at the temp you set If that is not happening replace the switch

https://gridology.ru/users/16295

i have seen this a few times. the m/w portion has seperate fuses and sometimes the cartridge fuse can be blown. it is located inside the top above oven. hard to get to without pulling the unit and getting the top off of unit.
others have had a failure in the microwave control board.

Check the connections to the oven heating element for oxidation. If the wire insulation at the connector looks like it has been overheated, you almost certainly have a bad connection.

Possible Solutions

Reset power to the product:

There may be a problem with the User Interface or Keypad, the Control, or the associated wiring.

• Power unit down by turning off the circuit breaker(s) for one (1) minute.
• Power unit up by turning on the circuit breaker(s).
• Monitor the oven for one (1) minute to ensure the error code does not display again.
• Verify oven operation.