Westinghouse Electric Refrigerators - Recent Questions, Troubleshooting & Support
Have a Westinghouse Refridge WSE6070SA. The fridge
Hi maxcoral,
This is just going to be a shorted display board. There aren't any
fuses or resets that would cut out the power to the display board. There isn't anything you can do at this point except to replace the display control board to fix the issue. If you're handy, you can replace it yourself. It will just take you 15-20 minutes. You may get replacement part from Sears. You may call them at 1-800-252-1698. Just get your model # ready when you call.
Hope this helps.
Thank you for using FixYa.
I am wanting to replace
contact this company here
http://www.allbrandonline.com/ you will be able to order your door seals from this company and they will mail them to you 1800-252-7500 is there number also remember after you install the seals to coat the seals with petroleum jelly or vaseline and leave the door of the freezer closed for at least 3 hours this causes the door seal to mold properly and keep the proper suction to make sure the door stays snug and grabs onto the frame if you have any questions message me back and please remember to rank how this opinion has helped it allows me to continue helping people in similar situations in the future on this site Thanks again Rick
I have a westinghouse upright/vertical freezer,
You have a short circuit. Start by checking your wire repair (after unplugging the freezer of course!). Make sure that the two wires cannot touch each other and are not crossed. If you or a friend has an electrical test meter and knows how to check for short circuits, this is the time to do so.
If your repair is good, look carefully for more chewed wires. A pair may have been chewed through and are touching, or one conductor may be in contact with bare metal on your freezer.
With an electrical test meter, you can set it to OHMS and check between either side of the plug and a bare metal part on the freezer. Only the grounding pin on the plug should read a low resistance to a bare metal part. If either of the other pins on the plug read a low resistance, follow back to find the short.
If you do not have a meter around and cannot find somebody with one, you will need to call in a technician to look at it. If you have to do this, make sure you get an estimate before they do any work. Good Luck!
How to remove drip tray at back of aeg fridge
On an AEG SANTO 3533, the tray sits on top of the compressor. There is a short metal "tunnel" on top of the compressor. The tray has a plastic clip in the middle which goes through the tunnel and latches up on the other side. To remove, reach to the back of the metal in the middle of the tray, press the plastic clip firmly down, and pull/wiggle the tray backwards horizontally to remove. Needed a torch to see clearly on mine. One of these things that's easy once you've done it once.
When Should You Consider Copper for Water Storage?
Copper has anantibacterial effect. Studies recommend storing water in copper containers for several hours before consumption to maximize this benefit. Some research suggests 48 hours. perhaps explore dedicatedcopper water bottlesfrom reputable sources for optimal water storage.
This refers to water, not juices.
Not finding what you are looking for?