Wahl Health & Beauty - Recent Questions, Troubleshooting & Support
My wahl clipper is very noisy, what should i do to
First, they need to have a drop of oil put on the cutters every time they are used. Second, there is usually an adjustment screw on the side of them to adjust the travel of the moving cutter. Adjust that so that it completely goes across the slots in the stationary one, but not too far or too noisy.
Wahl designer clippers pulling hair
Oiling blades and sharpen them will help to fix the issue. However several reasons can cause this issues such as the low power, broken blades etc. https://pakcentric.com/wahl-magic-clip-pulling-hair/
Putting a wahl 9307 back together
You will notice there is a little hook that the spring thing fits into on the device. You want the smaller part of the spring facing upwards and it should tuck in smoothly.
This is the smaller part of the spring facing upwards:
Then it gets tucked in as such:
Take note from the above photo that the square edges on the plastic piece go at the top of the blade piece and the rounded edges are at the bottom.
Then the bottom blade piece rests on top with the curvature facing upwards:
The rest should be straightforward!
1/17/2021 9:03:23 AM •
Wahl 9307
•
Answered
on Jan 17, 2021
I took my Wahl clippers apart to clean ......
Okay I fixed mine. this is I what I did and it works now take the big blade and put it on a table, take the little blade and put on top of the big blade if you look closely at the big blade you can see where the little blade went, make sure you allign the blades. next take the white thing dont know what you call it bit it rotates the blades put that on the little blade, take the gold piece align with holes to the big blade and take the silver piece allign with holes and then put the screws back in. when you put it on the clipper make sure the white piece goes in the hole that rotates the blades and sould go in fine
11/21/2020 10:55:25 PM •
Wahl 8550
•
Answered
on Nov 21, 2020
How to reassemble blades on Wahl rechargeable unit
I had the same problem and I eventually figured it out. The blade assembly has to be reassembled first then snapped back into place. 1. the bottom part has a little "nub" that the screws attach to2. the second part is the thin piece of metal with a ridge3. the white plastic thing, make sure the ridges are sandwiched together4. the small blade, the blades must face each other5. the large bladeuse the 2 screws to hold the assembly together, once assembled it snaps into place on the clipper. See attached picture for how it should look once assembled.It's STUPID that this is missing from the instruction guide that comes with the clippers.
4/9/2020 10:35:23 AM •
Wahl 8550
•
Answered
on Apr 09, 2020
How to reattach the blade on Wahl model number 9639
- Slightly loosen both blade screws, just enough to be able to shift the blade. ...
- Align bottom blade with the top blade. ...
- Extreme left hand tooth of the top blade must be on the first small tooth of the bottom blade.
- After blade is aligned, tighten screws.
- Plug clipper in.
Not finding what you are looking for?