Can I use the Wagner 915 1500 Watt On-Demand Power Steamer to remove tree sap from car's painted surfaces?
It's possible BUT it would probably turn it into a gooie mess and you'd just smear it around and create a bigger mess.
If you have any rubbing alcohol, isopropyl alcohol, around the house, this is your go-to tree sap removal solvent. We are talking about common alcohol, not some 100-proof stuff. You only need a dilute solution for it to work. Put a bit on a paper towel, micro fiber towel and dab it on. Gently wipe the sap off. Any rough moves with any solvent can leave a mark. Take your time! Let the solvent do the job, not the towel and your elbow grease. Rinse with warm water.
Best to you
Hi i have a Wagner
it has a tiny themo circuit in with the winding of heating element most heater made in china cheap so be looking for a contact piece like points on your old distributor on your car ...check if Ni-chrome element did not break somewhere can be fixed ...if you are check in the states harbor freight has some as well bout $ 29.00
Wagner power painter 2200 series will not ****
have you cleaned the suction tube going down into the paint bucket? if so did you make sure the check valve was reassembled correctly. if not it will never pull the paint up the suction tube into the pump to the gun.
Wagner 404 Plus Airless motor stops.
All airless sprayers are on-demand pumps. The two settings are prime and spray. When it is set to prime, the pump will draw liquid from the bucket below and pump it out the side tube and will never stop until you switch it back to spray. When set to spray, the pump will run until the pre-set pressure is reached, then stop. As soon as you start spraying, the pump will run until a few seconds after you stop spraying. Tip size and pressure setting will affect how long after you stop spraying the pump will run. A large tip and high pressure will cause the pump to run longer after you stop spraying.
Wii a bb work in a wagner 642 pump
Maybe for a little while . BB are made from coiled wire stock and most have a small flat on them that will hinder the performance of the sprayer.
Can i thin Valpar Bond Primer no 46620 to apply with a Wagner sprayer?
If you have an airless sprayer yes , you can thin with a small amount of water or use flotrol for latex available at home depot or other box stores. If you have hvlp system no you can't. The hvlp uses a turbine wheel to compress air to around 3-5 psi. You did not say model Wagner sprayer you have. I use my Wagner to 1800-2000 psi. If the job is small you will have to consider the clean u time usually abound 30-45 minutes. Good luck
Not finding what you are looking for?