I need operating manual for vapor white wing steamer
This is from an Amazon review. I have misplaced my manual and was searching for a pdf file without any luck. I think I have it under control if I only knew where to put my distilled water.Basic operation of the WhiteWing is: 1. Fill the tank with distilled water 2. Attach the hose to the steamer. 3. Attach the extension handles and attachment you want.(Be sure to watch the video and read the instruction booklet. Some of the attachments have specific uses and setup instructions) 4. Lock the finger trigger. 5. Plug it in. 6. Turn it on. 7. Wait 20 min. or until the pressure gauge reads between 3.5-4.5. 8. Get ready to rock - press the steam release button, unlock the finger trigger and start steaming. For many jobs such as countertops, shower stalls, stovetops, you will need to follow behind the steam, wiping with a cloth to remove the released dirt from the surface. Some jobs may require you to start with a non-toxic cleaner or grease remover such as Orange Clean or Method brand cleaners. Remember, you'll be breathing in vaporized cleaner. So be sure it's something non-toxic and non-irritating. I prefer the Method brand cleaners.
Hi -- For my White
Re: Low pressure on WhiteWing steam cleaner1. Make sure the safety switch for the hose handle on the right side of the hose handle is turned to the closed position. To do that, push it away form the hose.2. Make sure the steam release button (next to the on/off button on the control panel on the steamer) is in the Off position. 3. Make sure the safety cap is tightened.4. Make sure you have enough water in the tank (at least half a bottle of water)I hope this helps.
My Ladybug 2300 XL says
It is not the pump. The ladybug has a water level sensor that is faulty.
Ledybug are manufactured in china, there should be a customer support number on the user manual. Parts are usually available from manufacurer.
Regards.
7/15/2009 10:58:21 PM •
Vapor 2300...
•
106 views • 0 helpful votes
Steam sparging line attached to downcomers on HRSG
The reason for this is to keep the HRSG warm to reduce fuel costs. Due to the price of Nat Gas, it is adventageous to supply sparging steam to keep the HRSG warm so that when the Comb Turbine is called upon to start the HRSG metal temperature will be greater than ambient temperature.
Steam cleaner
Most upright steam cleaners like Hoover and Bissell, you put in the hot water, bissell does have a heater, but it only helps get the hot water a alittle hotter. But a model number would help.
Not finding what you are looking for?