Utilitech Pro Popular Questions, Answers, Tips & Manuals

light sensor failed or covered in dirt. or you have set it on double switch that means the stay on. to turn off permanent light flick the power on to the lights on off on. should go back to timer that has been set. 3 5 10 min.

Read the instructions that came with your liight (sic).

B and Q

Usually when a motion sensor light blinks LED or otherwise it means that the motion sensor is shot. The light itself is most likely good and for whatever reason you got a bad sensor upon purchase.

I know this is an old post but in case it helps someone else:

I had the same problem. On the sensor head (the bottom part of the light), you will see a plastic dome that can swivel about 360 degrees. Just behind that is a tiny dot maybe 1/8 inch in diameter. If you cover that dot with several layers of white tape the flashing stops and the light stays on. This defeats the dawn to dusk functionality because the light will always think its nightime, but I can always turn it off using the switch in the morning. The light is extremely bright when it is on, but many people struggle with the sensors never working right. If I hadnt already siliconed the light to my siding block, I would try to bypass the sensor altogether. For now the tape at least stops the flashing and I have light.

Sounds like the sensor has failed. The controls are supposed to be on the underside, and kept dry.

They flicker because the light is reflected onto the photo cell. Sheild the photo cell from whatever may be reflecting the light such as a building wall or over hang.