If a caton is 18" X 24" x24" how many cubisc feet is it
Quickly the calculation can be done easily in your head. 2 ft x 2 ft x 1.5 ft = 6 cu. ft.
In inches, 18 x 24 x 24 = 10368 cu. in. Divide this by cu. inches in 1 cu. ft (12 x 12 x 12 = 1728) giving you a result of 6 cu. ft.
Samsung CLP620 Printer says: Not Compatible Cyan Toner after storm
It depends of what is wrong. Perhaps the storm has nothing to do with having an empty cartridge. Perhaps lightening, induced a little current in the printer or in the chip on the toner cartridge.
You only can find out, by placing another toner cartridge in its place. And don't wonder if the error still is there. But then you have to call in an service engineer, because something serious can be wrong.
At least i hope you at least remover the cartridge once, to see if all contacts on the chip (and in the printer) are still clean and shiny.
Only clean contacts with a dry cloth or a cotton swab. Vever use anything sharp.
We have a Universal Shredder 38103 at our office.
On the upper right corner of the bin opening you will see a slot in the black plastic. I taped a part of a business card into the slot and it now works. Just make sure to unplug the machine when the door is open.
Shredder screen reads door open even if the door
Unplug it and then open i t up. You are looking for a piece of shredded paper that is stuck or jammed. Can even be a accumulation of paper dust. The piece won't be that big but most of the time that is all that is wrong. The paper either jams the door sensor or blocks it and gives the error. It can also be a bad door sensor or switch. Not very common but can happen.
Masking tape will not stick to windshield molding
The rubber molding probably still has a coating of mold release on it form when made. Try some plain alcohol to remove it, or some dish soap and water. It may be a silicon based mold release agent which is very stubborn to remove.
How to program MP6 player
Goto start setting control panel (add & remove programs) uninstall
the software that drives your unit , after re-installing the software
your unit will have fresh drivers installed , follow the steps for
your unit and you'll be back using your device .
Canon bjc-3000 will not print
You said that the light blinks 7 times. It means that the BJ cartridge (printhead) is defective
Remove the BJ cartridge and check that the contacts on the cartridge and cartridge holder are clean. Make sure the orange protective cap and tape have been removed and reinstall the cartridge. If the error occurs again after you resume operation, you may need to replace the BJ cartridge.
I hope this information allows you to resolve this issue. If you need further assistance, please post back with a comment to this thread.
If I've managed to answer your question or solve a problem, please take just a moment to rate this post....thanks!
Ativa DQ120D
The mechanism is overloaded. No doubt from debris inside. need to
to tak it apart, clean it all up, relube, and reassemble.
Ink tank installment
Recheck by removilng an reinserting cartridge
perhaps several times Is the cartridge identical
to the original, does it fit tight and latch down
securely
Not finding what you are looking for?