Model tm220w. how can I replace the belt?
I am unfamiliar with the model. Tumble drier design usually makes changing the belt difficult - almost in the extreme.
As the belt usually goes around the dryer drum and the drum extends the full depth of the cabinet, it is usually necessary to remove sections of the cabinet in order to allow the belt to be slipped from the drum.
The ones I have tackled have had no clear method to do this and I have been forced to adopt the principle of removing every screw accessible until the bit I wanted to remove fell off...
By the time the belt needs replacing, the drum bearings are often ready for replacement and it would be wise to replace them at the same time, often these are only blocks of fibre or strips of felt and when these wear out the cabinet soon becomes seriously damaged.
I have a tricity bendix
Check the fitting where the dishwasher hose connects to the drain. If it drains when disconnected, it is either kinking the hose when you put it back in, or the drain is plugged at the connection.
Washing doesn't smell fresh after cycles complete
Are you leaving the door open when it is not in use? If it is a front loader, you cannot leave the door closed when it is not being used, it will get moldy and smell bad. If this is what is happening, try doing a full hot wash with bleach. It may take a few times to get all of the smell out.
Hi there, I have a
You know, I think the best thing to do would be to replace the dishwasher. It is ten years old and a new one would be more energy efficient and you would save money in the long run.
Good Day, The dishwasher has been working very
first , contact a service agent or manufacturer and ask about a recall for potential fire problems
next get in an electrician to diagnose the fault as replacing a part may not fix the reason to caught alight in the first place
this is serious and should not be considered a diy project
Not finding what you are looking for?