Treadmill Doctor Exercise & Fitness - Recent Questions, Troubleshooting & Support

You need a new one. Contact the Electricity utility company and make a claim against them. They are supposed to regulate power and failed in the service you paid them for. ..

Question edited for clarity. Question moved from Washing Machines category.

Cybex International Inc. Recalls Treadmills Previously ...

U.S. Consumer Product Safety Commission (.gov) https://www.cpsc.gov > Recalls > cybex-international-i... Description: This recall involves the treadmills "Cybex 400T," "Cybex 410T," "Trotter 510," "Trotter 525", "Trotter 535", and "CXT+" that were recalled ... The number is at the bottom of the Recall information. Some have a breaker, but looking for it shows me that it has a separate power supply. You need to test components with a Multimeter. https://www.google.com/search?q=Trotter+510+breaker ..

Question moved from Cars and Trucks category. It is no longer available according to many of these articles. There are general tips only. https://www.google.com/search?q=Vitamaster+8713sa+manual ..

Question edited for clarity and make some real sentences. Question moved from Computers to make model series. Removers are usually the best best. They will collect in a small truck, take to the warehouse and wait for the next removal job to New Jersey and drop it off to the NJ address after the main move job is done. https://www.google.com/search?q=Brooklyn+NY%2C+removals+to+New+Jersey You may also consider 'Two Black Men and a Truck', but be careful. https://www.google.com/search?q=Two+Black+Men+and+a+Truck ..

Check motor....if motor ok check the controller

Check the motor belt, more than likely has a burnt spot in it and can cause a knocking

Hi sir, you must test first the motor: use battery for Motor Cycle 12Vdc, and see what happen with the motor. if the motor Run very well, the Problem will be with the Control board Motor. Some time will be The transformer, if have 2) the Bridge Rectifier, 3) The big Capacitor 4) IGBT 5)or some Faulty short between Solder. Look Carefully.

I just fixed the same 133 error, it's about the communication between motor module and upper panel. There is an 8 wires cable, uses standard RJ45 connectors. In my case, one of the RJ45 connector to motor module is poorly done by the manufacture, so the connection is not reliable, I re-do the connector, problem fixed.

Dear Sir:Please RUN the software calibration for easy diagnostic and troubleshooting.Your motor can be defective for various reason;1) ball bearing 2) Brushes 3) winding defective 4) Dirty 5) Lubrication, etc.sincerely. God bless you.

Either the drive belt is damaged or the belt is out of alignment due to worn motor shaft bearings.

adjust the reed switch, test for open or faulty, clean it, and tight the connector fery weel , see the diagram attached2) replace the batteries old by new ones, and clean the contacts batteries.3) tight the ribbon cables for keypads, clean it too.God bless you

If the walking belt slips when walked on, first remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both rear roller bolts clockwise, 1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each edge of the walking belt 2 to 3 inches above the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened. Now if this does not solve this problem then check the drive belt and adjust accordingly, also reverse the process of the above mentioned

go to www.fitnessrepairparts.com or www. doctortreadmill.com or www. treadmillpartszone.comGod bless you