Topcon Recent Questions, Troubleshooting Help & Support

I believe the GTS-6XX series is the non robotic version of the GTS-8XX series. And E-99 in the GTS-8XX series is when the station cannot write to it's internal memory. Try resetting it. If it comes up with the same error, the ABS circuit board needs to be replace. Unfortuinately parts have not been available for that unit for a long time.

https://docplayer.net/54621960-Fc-2600-operator-s-manual.html

Question edited for clarity. Question moved from Misc category. Different model but check Page 10 https://geodesical.com/es/pdfs/manuales/topcon-manual-estacion-total-serie-gts-4-en.pdf

TP-L6 series - Tiger Supplies

tigersupplies.com https://image.tigersupplies.com > Manuals > TO... Oct 20, 2021 - Repeat checking procedure above to confirm accurate calibration. • If the adjustment range is exceeded, "E72" (error) will be displayed in step ... 61 pages https://www.google.com/search?q=TOPCON+ES+error+E72 ..

If changing the batteries did not solve the problem, you could try resetting the remote. To do this, remove the batteries and hold down any button on the remote for about 5-10 seconds. Then, reinsert the batteries and try turning the remote on again. If the remote still does not work, it may be damaged and need to be replaced.

NO CORRECTION ERROR IN TOPCON CL_100 when switched on

Question edited for clarity 'make model (what it is)' Page 87 of the manual "NO CENTER" Center of eye can not be found. https://sandbox.revolutionehr.com/pms/resources/RevHelp/Topcon-KR-8000PA-AutoRefractor-InstructionManual.pdf https://www.google.com/search?q=topcon+kr8000pa+no+centre+error+code ....

Repairs in the link https://www.google.com/search?q=Topcon+GTS+601+repairs ..

www.fixya.com/support/t24060928-lensimeter_showing_initial_error_power

No one will tell you exactly. There could be several variants, you have to disassemble the device and look at it. Maybe there is something wrong with the circuit board, or with the contacts, or the laser transmitter has burned out and needs to be replaced.

Hope This Helps

https://www.youtube.com/watch?v=4PI09D5AYGA

Hello, have you already fixed it?

On what?

There are 2 small screws holding the rotating head motor in place. Likely you just need to loosen these screws, and adjust the motor position and retighten.

Contact the manufacturer: https://www.topconpositioning.com/support https://www.topconpositioning.com/support

I need a remote to work with my TOPCONPro TV i bought in HK.