Tissot T - Recent Questions, Troubleshooting & Support - Page 2
Tissot t-touch analog time is out of sync with
This is the tried and tested solution from this very nice gentleman. Many thanks to him (Ha Bi):
- Press and hold on to the T button until it beeps
- Touch the middle of the screen to change digital display to unit selection
- Press and hold the T-button until "Synchronize" comes up in the digital display
- Use the + button and - button to align the hour and minute hand to 12:00.
- Click on the T-button again. Congrats, you're done!
- Enjoy~
Must see blog for all T-touch users
http://myhabi.blogspot.com/2008/10/tissot-t-touch-battery-change.html
Battery replacement is it a dealer only job?
This is a Myth my friend.Anyone can change a battery on Tissot T Touch.The First models have 2 steps the Battery Replacement and Synchronization.After the Tissot Expert add the Reset as third step.
In my blog i have instructions with video how can you do that.
www.watch4maker.com
11/1/2014 4:59:34 PM •
Tissot...
•
Answered
on Nov 01, 2014
The digital time display and
Hi,You can try to so the synchronization to match the digital time and the analog hands.here are the step by step procedure including visuals, click on the
link.I hope this will resolve your issue.Thank you for choosing Fixya.
Synchronizing the manual and digital clocks
Push the middle button then touch the centre screen selecting the "nits" mode(24 C m), then push the middle button again for 5 seconds."Synchro" will appear on the display. By using pushers + and -, bring the two hands pre-cisely to 12 o'clock
Incrementation of the minute hand(3 steps=1 minute)
Incrementattion of the hour hand(3 steps=1 minute)
Press the middle button to validate the setting.
Tissot t-touch battery problem
If you take a jeweler's lupe near where the arrow is you will see the word "reset" in the plastic. There is a deep hole in the plastic with contacts below. That is the reset, and that is why you must use very sharp pointed tweezers to make contact with the back of the battery.I think if you do not have sharp tweezers, you can probably put a sewing pin down the hole, and then connect with a small screwdriver to the back of the battery
Hi guys,
The Tissot Touch watch is expected to need "SYNCHRONIZTION" periodically. (that is, to synchronize the digital and analog portions.) The Tissot manual tells how to do this. This manual came with your watch and is available online from the Tissot website.
good luck, Rodney
Haw to reset tissot t tuch
If you syncro you must touch the center until the option look open the press the middle button for 5 sec and you see the function Synchro.You must set the 2 hands at 12 exactly.greekdimis.blog spot.
Why Touch does not work after battery replacement?
Was the battery empty in the first place, or was the watch already defect?
Did you put in the correct and a new battery? or perhaps you did put n the old battery?
can you measure the voltage of the batteries, to check?
Just a few questions that came up with me.
Replace Battery on a Tissot Touch
When you need frequent re.Syncronizing of your Touch or after 2-3 year
maybe you need to replace the battery.
you need:
a CR1632 3V Battery (about 2€)
a very tiny screw driver
a very sharp knife
With the knife remove the bottom of yout Tissot, (you do not need to unscrew) it's just a cover to pull up like in this imaged
Now you can clean with a soft brush & remove the dust.
Use the screw drive to replace the battery,
put back the cover & enjoy
Reset a t-touch expert
Shortcut battery with AC contact. AC can be found on the sides of watch movement(very tiny). You have to use pointed tweezers: one end on battery+, another on AC contact for three secsIf you take a jeweler's lupe near where the arrow is you will see the word "reset" in the plastic. There is a deep hole in the plastic with contacts below. That is the reset, and that is why you must use very sharp pointed tweezers to make contact with the back of the battery.I think if you do not have sharp tweezers, you can probably put a sewing pin down the hole, and then connect with a small screwdriver to the back of the battery
Not finding what you are looking for?