Looking for a service manual for Thermador MC30WP/01 speed oven
The transformer that supplies the magnatron is fed from the same part of the machine that feeds the turntable motor.
The turntable motor is fed through one of the door safety switches.
Check the door switches and feed fuse. If a diode pack has failed, that will blow the fuse or even damage the switch as well.
7/28/2023 12:36:39 PM •
Thermador...
•
52 views • 0 helpful votes
Thermador Ice Bucket grey tab broke?
If the grey tab on your Thermador 42-inch built-in refrigerator's ice bucket broke, and you're unable to pull the ice bucket out for cleaning and drying, here are a few suggestions to try:
- Use a flathead screwdriver: Insert a flathead screwdriver into the slot or opening where the grey tab used to be. Apply gentle pressure to push or lift the ice bucket enough to release it from its locked position. Be careful not to damage the surrounding components or scratch the interior of the refrigerator.
- Thaw the ice: If the ice bucket is iced up and causing difficulty in removal, try thawing the ice by turning off the ice maker or adjusting the freezer temperature slightly higher. Allow the ice to melt, which should make it easier to remove the ice bucket. Be sure to place a towel or tray underneath to catch any melting ice or water.
- Contact Thermador customer support: If the above methods do not work or you are uncomfortable attempting the repairs yourself, it is recommended to contact Thermador's customer support directly. Provide them with the model number (T42BD820N810) and explain the issue with the broken tab and the difficulty in removing the ice bucket. They will be able to provide further guidance, including potential solutions or arranging for a service technician to assist you.
6/26/2023 2:41:48 PM •
Thermador...
•
65 views • 0 helpful votes
Glasses etched and spotted in Thermador dishwasher soft water
I have spent a 50 year career in catering using dishwashers and seen all the damage that can cause. Etching is caused by using too much detergent. They tend to be based on Caustic Potash. Use as little as you can get away with. Rinse aids don't normally cause spotting, but having the water too hot can. If you are having problems, change the detergents and lower the temperature. You can also try Calgon water softener, but only a little. Also make sure filters are clean and run a liming solution through the machine once every 6 month. Before I retired, I was manager of a Toronto Airport business class lounge, and we washed thousands of plates and glasses a day 5:00am to 11:30pm. We descaled every week.
7/11/2023 8:15:02 PM •
Thermador...
•
43 views • 1 helpful votes
Thermador SMW272 Microwave Power Outlet Burnt
That is a funny looking unit! You know we are Fixya and not Thermador right?
There must be too much heat back there and it is over heating the socket and the microwave lead which isn't heat resistant and normally only has its own heat to contend with.
What I would do is pull all that appliance out an put it on the other side to the kitchen, and ask a bigger electrical contractor to MOVE and REPLACE a pair of outlets in a kitchen for a remodel. What I would do is to certainly move the microwave outlet to the cupboard next door. Make a decision whether to move to 220 oven outlet as well. Don't mention anything about burning plugs or the 87 volts. Tell them you would like Industrial Quality Outlets and not domestic. I reckon that will fix the problem.
1/17/2023 7:45:04 PM •
Thermador...
•
140 views • 0 helpful votes
Some of the control knobs on my Thermador Rangetop PCG366W sink all the way in so that you can't see the writing on the knob, is that normal? If not, is there a fix for it?
Burners Do Not Start
Hand on burners
The Burners Do Not Start
There are several solutions for this problem:
The main gas supply may not be turned on. Make sure it is turned on.
Check the power supply and make sure the unit is plugged in and the circuit breaker has not tripped.
Make sure the burners are properly positioned.
The igniters may be dirty. Carefully wipe the igniters with a cotton swab dampened with water after they have cooled down. Gently scrape the soil off with a toothpick. Avoid exposing the igniters to excessive water as a damp igniter may not light up. Remove any lint that may remain after cleaning.
The ignition will be quicker if a cooking pan is on the grate. Ignite the gas at full and once alight, turn it down to around 50%. It should lock on within 6 seconds.
Does the burner click when the burner knob is in the ON position? If yes, you may have a wiring issue at the outlet that the appliance is connected to. Turn off the main gas supply and contact a qualified electrician to fix this.
Does the burner click when the burner knob is in the OFF position? If yes, check for the following:
1. Check to see if the burner cap is properly placed and the igniter is not wet or dirty.
2. Check to see if the regulator supplied with the unit is installed properly. The arrow on the regulator should be pointing to the appliance. Please call a professional installer
1/16/2023 6:51:37 PM •
Thermador...
•
45 views • 0 helpful votes
I have a Thermador CM302BS oven and it will beep just once about every 30 minutes. No lights are on or anything?
If your Thermador CM302BS oven is beeping once every 30 minutes without any visible indication on the control panel, it's possible that the oven is experiencing an error or malfunction that is not being properly displayed. Here are some steps you can take to troubleshoot the issue:
- Check the owner's manual: Consult the oven's owner's manual to see if there are any troubleshooting tips related to the beeping issue. Look for any error codes or messages that may be related to the beeping.
- Reset the oven: Try resetting the oven by turning off the circuit breaker that powers it, waiting a few minutes, and then turning the circuit breaker back on. This can sometimes clear up temporary issues with the oven's electronics.
- Check the oven's self-diagnostic system: The Thermador CM302BS oven has a self-diagnostic system that can be accessed by pressing a series of buttons on the control panel. Consult the owner's manual to see how to access the self-diagnostic system and check for any error codes or messages.
- Contact a repair technician: If you are unable to resolve the issue using the above steps, it's possible that there is a more serious issue with the oven's electronics that requires the attention of a qualified repair technician. Contact Thermador customer support or a local appliance repair service to schedule a service call.
It's important to address any issues with your oven promptly to ensure that it is operating safely and efficiently.
Replacing the TRD sensor in a Thermador double oven.
Hi,
Please look on page 40 of the manual for the Thermador SMW272 B Service Manual to find specific directions for removing the sensor. You can text "SUPPORT" to 53730 for quick access to such documents or call 1 (800) 735-4328 to speak to Thermador.
Thank you.
10/17/2022 6:20:31 PM •
Thermador...
•
115 views • 0 helpful votes
Not finding what you are looking for?