My register is only printing on half paper
Assuming you have the correct thermal paper in the register, here is something to try:
The SPS-320 has an electronic journal that can be printed to memory rather than live on paper.
To print the journal entries, follow these steps:
Turn off the register.
Hold down the "Journal" button (usually located on the keyboard).
While holding the button, turn the register back on.
Release the button. The journal entries should now print.
Check for Errors:
Review the register's display for any error messages or codes.
If there are error messages, consult the user manual or seek professional assistance.
Contact Support:
If the issue persists, consider reaching out to Sam4S customer support .
4/11/2024 4:38:56 PM •
The Office...
•
18 views • 0 helpful votes
Cordless hair straightener charge until green, then the on button flashes white & wont turn on.
Make sure the charging cord is securely plugged into both the flat iron and a power outlet. To eliminate any power source issues, try using a different outlet or USB port for charging. A device reset might resolve temporary problems. Unplug the flat iron from the charger, then reconnect it and attempt to power it on again. Examine the charger cord and flat iron for any obvious damage, like ripped wires or faulty connectors.
I'm installing a Rev-A-Shelf Base Organizer model 448.
I have inserted and removed the unit a few times but now it seems to be caught on one of the 3 slides at the bottom...any advice/?
- Check for Obstructions: First, inspect the area around the slides to ensure there are no obstructions such as screws, nails, or other debris that might be causing the unit to catch.
- Inspect the Slides: Carefully examine the slides themselves to see if there are any visible issues such as misalignment, damage, or debris buildup. If necessary, use a flashlight to get a better view.
- Adjust the Slides: If you suspect that one of the slides is misaligned, you may need to adjust it slightly to ensure smooth operation. Refer to the installation instructions for guidance on adjusting the slides.
- Lubrication: Apply a small amount of lubricant to the slides to help reduce friction and ensure smooth movement. Be sure to use a lubricant that is safe for use with metal slides.
- Double-Check Installation: Review the installation instructions to ensure that the unit has been installed correctly. Pay close attention to any steps related to attaching the slides to the cabinet or adjusting their position.
- Remove and Reinsert: If none of the above steps resolve the issue, carefully remove the unit from the cabinet and then attempt to reinsert it, making sure to align the slides properly and avoid any obstructions.
- Seek Professional Help: If you're still unable to resolve the issue, it may be necessary to seek assistance from a professional installer or contact Rev-A-Shelf customer support for further guidance.
By following these steps, you should hopefully be able to identify and address the issue causing your Rev-A-Shelf Base Organizer model 448 to catch on one of the slides at the bot
Not finding what you are looking for?