Tag Heuer Watches - Page 2 - Answered Questions & Fixed Issues
Had a new battery fitted
To reset the chronograph dials back to zero do the following:
1) Pull the crown out to the position where the date can be adjusted and push the buttons.
2) Pull the crown out to the position where the time can be adjusted and push the buttons.
My Tag Heuer chronograph will not reset to zero.
Try the following, which I discovered by accident on my Tag Professional.
Pull the crown out to the first position, and then you may find that successive pushes of the upper pushbutton will move one of the chrono hands by one division, and the lower pushbutton will move a different chrono hand. Similarly if you pull the crown out to the second position, the pushbuttons will control the other chrono hands. In this way you can set each of the chrono hands to their zero positions.
Hope this works for you.
Geoff
2/26/2019 4:18:06 AM •
Tag Heuer...
•
Answered
on Feb 26, 2019
•
28,796 views
I need to stop alarm on watch MSP74576W
Hold right bottom button and then press right top button, while looking at tge watch face, this will toggle a little AL display indicator over the minutes digit
How do I set the alarm on model wau111a tag watch
Pull out the crown to the alarm setting position. The crown is located on the right side of the face of the watch. Pull the crown out until "AL", the alarm indicator, is shown on the watch. Depending upon the model of your Tag Heuer Aquaracer watch, you will either pull the crown out in the first or second position.
Select the hours and minuets for the alarm. Once your watch is in the alarm setting position, press the bottom right button on your watch. This will enable you to select the hours and minuets that you want to set the alarm for.
Set your alarm. To begin setting your alarm turn the crown clockwise until the desired hour or minutes are displayed on your Tag Heuer Aquaracer watch. If you happen to accidentally pass the alarm time, turn the crown counter-clockwise the get back to the desired alarm time.
Save your alarm. When you are ready to save your alarm, simply push in the crown. Once your alarm sounds, to silence it press any button on your Tag Heuer Aquaracer watch.
How to synchronize Tag Heuer CAN1011.BA0821?
Unscrew the crown, start the stop watch on the time signal. Stop the second hand at 12 o'clock and reset the time (taking out the back lash on the minute hand) Start the watch as the stop watch second hand hits 12. Screw down the crown. Done.
10/24/2014 6:54:50 AM •
Tag Heuer...
•
Answered
on Oct 24, 2014
•
586 views
My tag heuer is starting to run slow
If it's 5 years or older it's time for an overhaul. Make sure that they are going to replace the mainspring when doing the overhaul. So many repair shops do not do this simple task. It requires them to tear the watch down all of the way.
gabe
10/22/2014 2:46:37 AM •
Tag Heuer...
•
Answered
on Oct 22, 2014
•
1,541 views
Not finding what you are looking for?