SYMA Toys industrial Toys - Recent Questions, Troubleshooting & Support

fully charge your heli----turn on transmitter-wait 2 seconds-turn on heli
wait for blinking green led to stop blinking-turns steady.....rev up
with a quick full throttle and back to idle--happy flying

How much charging time for double horse 9077 egle...using original charger

Moving to solution section so more people will see it:Infrared is different band of electromagnetic spectrum from radio and is subject to the same problems as radio waves, namely, noise, transmitter problems, and receiver problems. the receiving antenna will not be a wire, it will be a infrared photocell. The sending "antenna" will be an LED.A few things to try..- make sure that nothing is covered on your handset and the helicopter that did not come that way- Switch channels- try a different location to see if anything in the environment is interfering, it could be something generating a lot of heat (including bright lights or sunlight) or another infrared device, like a remote control or some wireless devices like headphones and 3D video game systems with active shutter glasses.- turn everything else off where you are trying to fly - might have to unplug electronics and remove batteries from remotes to make sure they are not emitting- try linking a different helicopter or different controller that you know works to see if it is on one or the other of yoursI tried putting my hand over the emitter and the helicopter, and could not block the signal. I flew mine to the balcony out of site, and it still responded fine, so the signals bounce around enough quite a bit.

My helicopter used to do that too I called the company and told them my problem they said to change the batteries in the helicopter in a week they delivered the batteries and my helicopter was working agaim

check if the servo that controls the pitch is working

It is no use to buy a new charger if the problem is a short. Indications are that it is. When the batteries are in need of replacement and wont charge up, overheating of the charger will also occur.

Mine does the same exact thing it just will not lift off the ground, nor will it charge. I have tried changing the wings, and batteries but it is still a no go... But i am pretty sure it is because the motor will is not getting enough RPM's or torque. any help is much appreciated Thanks, Michael

Boat only works in water, or you can use a copper wire and permanently connect the two copper drive shafts and it will work out of water.