Sunpentown Cooktops - Page 9 - Recent Questions, Troubleshooting & Support

First You should have a technician to come and check it out. But my first thought you have a obstruction in the tube going to the burner, Might be a piece of food that has fallen into the Ventura,.

Apparently there is a service manual offered on this site for $10. Modern Maid Gas Cooktop PGT193UB2 Service Manual in PDF format Appliance...

Most likely the control / clock needs replacing

Most likely the switch for that element is defective, although it could also be the element itself that's bad.

If it's new, call warranty service. Anything else may void warranty

Natural gas stove

Try cutting power to it to reset electronics. If that doesn't work, then most likely a control issue

Switch that controls that burner is bad and needs replacing

usually spares online ie ebay

You can buy ceramic cooktop cleaner

l reckon it could be a busted thermostat. Call a sparky..

Never seen one the hole is cut to size of the top so in most cases you go like for like .

You will have to clean the control area connections .

If the lights are coming on there is a great possibility that your plate needs replacement. Unfortunately electronic items usually don't come with any warranties, so make sure it is the plate before purchasing a new replacement. Regards bandha

The heating coils in the oven need to be inspected very carefully where they plug in to the oven wall. You will need to remove the back covers and check the insulators and wiring harnesses. Over time the insulation can break down and oxidize the metal connections. You can use a voltmeter or test light to verify that the coils are getting voltage from the thermostat/switch. replacing parts is cheaper than buying new if you can find the parts.

Check to see if the control has been changed to C* instead of F* always unplug electricity before attempting to repair on any electrical appliance

Is the power correct voltage? always unplug electricity before attempting to repair on any electrical appliance

You should never use large amounts of water on any electrical appliance. If the moisture is under the glass, it will need to be replaced. always unplug electricity before attempting to repair on any electrical appliance

Try Google the model and word parts.

Try turning off the breaker for 10 sec and then try the unlock sequence