Sunbeam Food Mixers - Page 7 - Recent Questions, Troubleshooting & Support

Sounds like motor is burning out or has burned out. How old is it and do you use it for heavy things. They won't last if it is a cheaper model. I had a cheaper one and got very little time out of it. I bought a lot more expensive one and it has lasted several years.

Don't know a solution, because I am having the same damn problem.
I am very discouraged with this product.
It is a piece of ****.
I am thinking about taking it out back and shooting it with my 270 I bought.
That is the only solution I know.

Hi Paul i have the manual to this blender i can help you over the phone if you want to turn it on. I have this manul is my mum passed this onto to me without the spindle part of the food processor. If you find that your item doesn't not work at all after trying it with the manual will you sell me the spindle part?

Here is a link to the complete manual for your mixer: http://kitchen.manualsonline.com/manuals/mfg/sunbeam/2388_4.html

try the link you may have to copy and past it in you web browser.http://davesrepair.com/pdfmanuals/mmmaintpage.htm

Nothing different between blenders working in US then Colombia. Your blender is defective. Bad luck you bought it in US and never tested before taking it to Colombia. Well, actually a blender can work with just one speed!

try ticking with a long screw driver. Metal tends to stuck but when knocked easily with another piece of metal it tend to loose.

try the following sites www.eserviceinfo.com/equipment_type/model### www.freeproductmanual.com/manufactures_name/model### www.info.com/manuals www.s-manuals.com/manufactures_name/model### at the browser type the following information sunbeam disassemble procedures for make/model ### you could look at www.youtube.com/disassembling mixmaster model 2351

I hope this helps. I found on mine that the rear screw on the "neck" had become slighty loosecousing the release to not fully disingage. I had to remove the dome shaped cap in the middle of the speed control knob, pops off fairly easy, to gain access to the nut to tighten it. Hard part was trying to hold the screw head still while I used a small screw driver and small hammer to tap the nut tight, very limited space between the "neck" and motor body.

btsctn

The normal procedure would be to take the appliance to a local Authorised Service Agent and get them to assess the problem. They will then obtain the parts for you if it is deemed to be a manufacturer fault.