What are codes 07E8 and 07E9 for 2010 Subaru forester?
those are not codes those show that you didnt read instructions completely on the use of your scan tool those show that their are codes present depending on unit you either hit next or codes or enter rescan vehicle and continue to next page when those show up
CEL light, cruise control and brake light blinking and traction control light (codes P2096 and C0057)
I have seen this happen with dirty or loose connection ether at or around the battery and also the connection at the under hood fuse block itself . Sometimes its the connections under the fuse block. Check them all , and while its apart apply some dielectric grease to each connection, If you can find the connection to the ABS pump I would start there. The ABS is part of traction and stability control . Disconnect the battery before unplugging anything tho .
11/15/2021 12:34:42 AM •
2012 Subaru...
•
1,390 views • 0 helpful votes
My radio won’t turn on. My door ajar light WONT illuminate. Neither will the map lights, heater. Please help
The problem is that even if you replace fuse #2 and fuse #8 in the engine compartment, possibly restoring map lights, air conditioning, heater and radio, it is very likely some component is busted and drawing too much power through the fuses. It is possible that the bearings in the heater need oiling finally drying out after 10 years That fuse #2 handles multiple power on functions and if it is blown, you have to round up the usual suspects, i. e. test further to see just which component has truly failed..
Not finding what you are looking for?