Star trac Exercise & Fitness - Recent Questions, Troubleshooting & Support
Treadmill Star Trac 4500 won't start
Checkout this latest Tops & Tunics
Product Name: *Fancy Graceful Women Tops & Tunics*
Fabric: Rayon
Sleeve Length: Three-Quarter Sleeves
Pattern: Embroidered
Multipack: 1
Sizes:
XL (Bust Size: 42 in, Length Size: 27 in)
XXL (Bust Size: 44 in, Length Size: 27 in)
Country of Origin: India
Easy Returns Available In Case Of Any Issue
*Proof of Safe Delivery! Click to know on Safety Standards of Delivery Partners- https://ltl.sh/y_nZrAV3
8/22/2021 4:33:13 AM •
Star trac...
•
Answered
on Aug 22, 2021
Current over on screen
Had the same problem. Had the motor tested it is not the motor. Tested the circuit breaker switch on the unit and that was ok. The problem is the motor controller. http://fitnessgraveyard.com states they can fix these for a flat fee of 195. I am about to send mine in.
Light says no rpm
Replacement Parts for Fitness Exercise Equipment at SPORTSMITH
This message appears when the rpm sensor becomes damaged or misaligned.Remove the shroud located at the front of the treadmill to gain access to this component.
The rpm sensor is locted between the motor and the flywheel, there should be about 1-2 credit cards gap between the sensor and the flywheel. Large amounts of dust and debris buildup on the flywheel itself can cause the sensor to not pickup a reading, however if the flywheel appears to be clean, the sensor should be replaced.
After replacing the sensor, you will need to run the unit through a calibration procedure.Press and hold the "0", "1", and "Start" at the same time, then release the "1" key.The display will read MAINTENANCE, then press and release the "8" key.After the "8" key has been pressed, On the newer 4000 series press the "Heart" key to perform calibration.Once the "Heart" key is pressed the calibration will perfom. After the process is complete, the NO RPM error should clear itself out.
NO RPM Error and Why it Displays on StarTrac treadmill
11/30/2015 4:20:29 PM •
Star trac...
•
Answered
on Nov 30, 2015
ST Fitness 8920:
Press (incline +) and (speed +) on the control board at the same time for a few seconds.
Not finding what you are looking for?