Stanley Garden - Page 10 - Recent Questions, Troubleshooting & Support

Hi, W/D here.

The blade changing is accomplished by pushing the yellow button and pulling the old blade out. It is reversible. If there is no blade at the ready, there may be more in the body of the knife, which are located behind a swing out panel on the handle. You'll need to push in the yellow button when installing the blade, and once the blade is in, release the button, and moge the blade until it clicks in place.

--W/D--

the most simple way to run the radio from a charcher is to hook radio and charger to a battery
the charger will charge battery and battery will supply constant volts to run radio

You forgot to include the manufacture of this tool box which is needed. The catagory used as showing is for a chain saw instead

The lower part of the plastic foot on each tripod leg just screws off. Change just one cell at a time so you don't get confused which way the cell goes in. Use alkaline cells, not zinc-carbon which tend to leak. Good luck!

Cut the end of tube on a angle.There should be a rod with what looks like a plunger at the end.pull the rod back as far as it will go and lock into place.slide tube of caulk into gun with open end of tube towards the plunger.should be a slot at other end where nozzle fits in.take a piece of wire and poke a hole up the nozzle of the tube.release the rod and sqeeze the handle a few times you should see the rod start moving.if not turn the rod until the teeth are facing down.then try again .you should hear a clicking sound and feel pressure and caulk will begin to come out of tube and you will be caulking.Good luck.If you still have problems just come back to fix-ya and we,ll help you through it.

Hello digi..... to set the keypad you need two people. One on a step ladder to push in the button on the garage door opener motor which makes the light blink. then while the light is blinking punch in the 4 digit code and hit enter.

To set the remote, push the button on the motor so that the light blinks then hold the remote nearby and push the button on the remote.

Joe

Thanks for choosing Fixya!

Make sure that you are using staples made for this tool. Remove the staples and look for a jammed staple at the drive head which will block further staple movement. Make sure there is spring tension at the rear of the staple row when the slide is closed. Hope this helps!

To do the job right, you make a miter cut, then a coping cut. There is an excellent article on this at:
http://www.wikihow.com/Cut-a-Coped-Joint-in-Wood-Trim
Getting a nice-looking coped joint is very satisfying, but takes a bit of practice. But it's worth it. Miter joints are great for picture frames and trim on furniture, but not for trimming a room.
Good luck!