Stanley Measuring Tools & Sensors - Page 2 - Recent Questions, Troubleshooting & Support
How do i recharge Stanley fatmax 700
You will have to buy charger for Stanley fatmax 700 it will cost you around 12$ to15$. You can buy it from any online shopping website like eBay or any other.
6/17/2018 3:54:05 AM •
Stanley...
•
Answered
on Jun 17, 2018
Please advise me to how to use and how it work as
Hold the unit flat on the wall. Press and hold the side button (you will hear one short beep). Holding it to the wall, slide the sensor left or right, when you get near a wall stud, the lights will begin lighting up, when centered on the stud, the top light will be lit and it will beep continuously.
4/8/2018 5:18:27 PM •
Stanley...
•
Answered
on Apr 08, 2018
How to open stanley fatmax
How do I change the blade on the quick change/instant change knife?
Warning: Blades are sharp and can cause serious injury. Be extremely careful when handling blades. Wear eye protection and dispose of used blades properly, such as wrapping in duct tape.
FULLY EXTEND THE BLADE.
Press down and forward again on the slide button until the button is in the full front of the top slot (0 through 3 in the below picture).
Note- the blade must be extended beyond the 3rd detent position. This will cause the slide button to remain in a down position, allowing the blade release button to operate.
PRESS AND HOLD THE BLADE RELEASE BUTTON ON THE FRONT SIDE OF THE KNIFE. (Step 4 in the below picture)
Note- if the blade is not fully extended beyond position 3) , the blade release button will not work.
Remove the old blade carefully.
Insert new blade.
NOW, RELEASE THE BLADE RELEASE BUTTON.
ENSURE THE BLADE IS LOCKED IN PLACE. If the blade does not retract, try carefully giving a slight tug on the blade to reseat.
I brought a stanley fatmax retractable knife, have
Are you using Stanley Blades or off brand? Hey, I use off brand but sometimes it does make a difference. Second, make sure the blade slider is clean. If you were cutting shingles, for instance, the tar gets in there and screws things up.. try WD-40 spray it liberally all over the blade slide and buttons. If that doesn't work and you purchased it at a Menards store, I can speak of experience they'll replace it no hassle.
I hope I helped
Not finding what you are looking for?