THIS APPEARS to be your BATTERY:
"Sony HBH-DS220 HEADSET battery"$13.15 shipped NEW from eBay:
eBay: 182763761261
*you may find a better price elsewhere*
Battery REPLACEMENT is shown in this YOUTUBE:HBH DS 220 Auseinanderbauen disassembly
It's REALLY out of focus but you should get the idea!
Anthony
The wire to headsets can get damaged (usually not visible from the outside, as the wires inside the covering can be very delicate, to keep the size of the wire down) from throwing them in the pocket, purse, etc. Try a set from a friend to make sure the device is still working itself.
Phone: Turn on Bluetooth and Bluetooth visibility. Keep it close to the headset (20 cm).2. Headset: Switch it off. Press and hold down the on/off key until the pairing icon appears on the display.3. Phone: If your phone supports auto pairing, press YES when Add device? appears to complete the procedure. If not, continue with the next step.4. Phone: Follow the applicable User guide to pair with a Bluetooth headset. You may need to enter a headset passcode (0000).
try wrapping it in a towel placing it in the freezer for a few days, move it to the fridge for a day and then out in the partial sun, like a windowsill for a day or two, this will help pull out the moisture that is deep in the unit, it's worth a try. best of luck
Hello People!
I Fixed my MW600... :D
WHAT HAPPEND?- I was listening music and it fell from my arm for the chair, about 30cm height and after that, it not power again...
HOW I FIXED IT?- I had to disassembled it. I had to remove its battery, spinning a little the battery and put its back. I pushed the power button and it worked... :D
Follow this video, step by step, for disassembly the mw600.
https://www.youtube.com/watch?v=UyEC33sUS_4
Please, be careful!!!
Good Look!
Below solution from talk.sonymobile is perfectly worked for me. Please try this:
i got the same issue and i have to fix it myself. Here is the step:
1. Under the female micro usb has a "small black plastic film" was glued to cover a "s c r e w". pull this film out.
2. "S c r e w" out this "s c r e w", pull out the bottom cover of the WM600. note: keep your eyes on the plastic power button, dont get it lost.
3. Look care fully inside u will see the battery, there is a small gap between the battery and it cover, use tool like tweezers to separate the battery and it cover a little bit. after that the WM600 will turn off.
4. tied everything back to its original
5. charge it for a while and then press power button to turn it on.
if you got any problem of my ideas, leave a comment, i will attach the pictures for each step.
Sorry for my bad english.
Good luck.
I am having this problem as well.
A repair guy told me its probably the antenna's connections to the circuit board, but he couldn't fix it.
I'm searching for a solution...
Sim contacts may be dirty, either on the card or phone.
remove sim card and GENTLY rub a pencil eraser on the contacts to clean, then test. If you can access the contacts on the phone, do likewise. If not, then you'll have to use an Ether based cleaner, Like electrical parts spray ( available from your local auto parts store) .
be careful not to spray too much into the phone, as once the spray gets inside it takes longer to evaporate. You can counter the time by using compressed air to speed drying of the phone interior without taking it apart.
Hope this helps!!