Sony Office Equipment & Supplies - Page 7 - Recent Questions, Troubleshooting & Support

The unit must be on Standby and then you press the reset, <,> and enter. I would recommend doing it a couple of times. You can do this from the remote. I would assume it can be done on the units control panel also. The main thing is to have the unit in standby. It doesn't work if the units not in standby mode.

Sounds like a piston ring has failed.Do a compression test to be sure its a ring or valve stem seal.

Hi Douglas.Try going into your display settings and change your screen refresh rate/display. If your screen refresh rate is too high/too low this will cause your issue. Also check your screen resolution. Hope this helps.