Hi nick, there can be many causes for this fault.
1. your speakers or speaker cables are faulty, then this problem will come up.
2. your installation is done incorrectly, or with the wrong gauge of power cables can cause this problem.
3. your vehicle battery could be weak.
4. you could have an internal problem with the amp only, which needs repairs.
Hi, check all the switches on the face panel, if the switches donot have a "click" feel when pressed then they are faulty.The face panel then needs internal repairs. Also check the gold connections behind the face. Check to see if all the contact pins are clean and shiny, and the same goes for the contact pins on the head unit side as well. cheers.
The directions to remove the Sony CDX-S2000 are in the operating manual, starting on page 15. You need the release keys that came in the original packaging before installation. The installation manual also shows these steps. First remove the front panel by pressing in on the bottom left corner. Then pull the panel towards yourself. This is shown on page 7. Next engage the release keys on sides of the protection collar. (Use the wide end of the keys oriented as shown in the picture). Pull out the keys to remove the protection collar. Reverse the release key and face the hook on each key towards the AM/FM/CD-player. Insert the keys together until you hear a click. Pull the keys out to unseat the unit. Now you can pull the unit out of the bracket.
Hi, Error messages can be found at https://www.sony.com.au/electronics/support/articles/00008857. E:62:10 has nothing to do with the LCD but is a generic error of the stabilizer. This is a very well known problem that happens a lot and still today with Sony camera's. After less than 3 years of use the stabilizer breaks down, making it impossible to take sharp pictures, and displaying the dreaded E:62:10 error message. Thousands of users on the Internet have the same problem, read the website http://sony-e-62-10.tk/ or search E:62:10 on the Internet or on YouTube. A temporary solution could be available at https://www.youtube.com/watch?v=S53D3EfDVk0
Information taken from owner manual.
Before operating the unit for the first time, or
after replacing the car battery or changing the
connections, you must reset the unit.
Detach the front panel (page 5) and press the
RESET button (page 6) with a pointed object,
such as a ball-point pen. Note Pressing the RESET button will erase the clock setting and some stored contents.