SkyScan Audio Players & Recorders - Page 2 - Recent Questions, Troubleshooting & Support
I am having trouble setting
taking the batterys out and leaving them out for 60 seconds or more will in effect reset the clock. Put the new batteries in and wait for the skyscan to detect the outside temperature (if this unit has a outside sender). after this show on the screen push the button that corresponds to your time zone. You can now set the clock with the push buttons or take the clock to a wall that faceing? ( you don't say where you are located), the WMV signalyou need to set the clockto is coming from Colorado USA ( if your in the us) so make sure the back of the clock is facing toward colorado. let the clock sit overnight as the best signal will be recieved when its dark and especially in the very early morning, just before sunrise. this should automatically set the clock for you. good luck
I lost my manual, now
Ours has a customer service phone # on the back (757) 460-2483 or Google that SkyScan Model # and the directions I bet are on the internet.
I cant find the manual so I dont remember how to
Press the Alarm button. The weekday alarm symbol will appear. Then press and hold the Alarm button for 2 seconds to enter the set mode (the hour will blink). Use the up/down buttons to choose the hour for the alarm (note the A.M./P.M. if in 12 hour mode). Press Alarm again and the minute will blink. Again use the up/down arrows to set the desired time. Press Alarm once more to exit the set mode.
To activate or deactivate the alarm, press the Alarm button until the weekday alarm icon appears. Then use the up/down arrows to activate or deactivate the alarm. When the alarm is set and active, the time will show. If the alarm has been deactivated, then dashes will appear instead of the time.
The single alarm is set and checked similarly.
I hope this helps.
Cindy Wells
(I suspect that the weekday alarm icon continues to display when the alarm is active.)
Not finding what you are looking for?