Sears Building Materials - Page 6 - Recent Questions, Troubleshooting & Support

Are the sensor lights located on each side of the garage door opening? Have you checked to see if they are in alignment with each other? Also check to see that any wire from the sensors are disconnected on the motor or at the sensor itself. Good Luck! Countrycurt0

Which rail?

No the time on is not adjustable.

some thing blocking sensor or laser is not in proper alinement

yes, and not that bad of a job. parts on eBay or other online sites.

hits floor and starts back open

Lift Master Security Plus remote works only intermitenly, It seems to lock after a few tries, Works from inside garage, Seems to lock up after few tries, Wall opener fine. Changed batteries several times. Can't understand why it works and then doesn't. Tried cleaning sensors and wires,

Stacy, get a ladder and climb up to the opener. The directions are there, but typically you press a button for x seconds, and then press a button on the remote. This handshakes the two units. continue for other remotes.

Leave car outside. Seriously, try a little more force to force adjustments.

Yes. If you go to this website it will cross reference between Craftsman and Chamberlain/Liftmaster.

http://www.geniedoor.com/sears-liftmaster-and-chamberlain-cross-reference

IF YOU ARE TALKING ABOUT THE ROLLER ON THE DOOR - THE TRACK IS TOO WIDE ALLOWING THE ROLLER TO COME OUT. USE THE CLAW END OF A HAMMER TAP THE TRACK MOUNTING BRACKET AT THE WALL TO MOVE THE TRACK IN CLOSER TO THE EDGE OF THE DOOR

Need More Info

THE POLARITY OF THE WIRES TO THE WALL BUTTON MAY BE REVERSED.

Try the programation with the central control of de wall hold light boton then press de open botton (dont un unpress the light botton. Then put the control about 2 inch of the main control until its open or close the garage door. Let me now if it work. regards

Have you tried to reprogram the chanel again?
Changed the battery?

New door openers have a different radio frequency than the old models. This is most likely your problem and you will need to buy the keypad that is compatible with the new opener.

Anytime a door opens and/or closes randomly or doesn’t work consistently I look for a smashed wire between the motor unit and the wall button.

If the wire is smashed the insulation becomes so thin that power will leak thru the insulation and activate the door or interfere with the remote signal.

Loosen the staples with a small screwdriver and slide the wire about ½ inch to move any areas of thin insulation away from the staples.

The second thing would be a bad wall button or a remote with a sticking button.
Or a remote in someone’s purse that gets the button pushed by other stuff in the purse.

The test is to disconnect the push button wires at the power unit. If the self operation / interference stops you have located the problem. If you reconnect the wires and disconnect the wire at the wall button this will tell you if the problem is the wire or the button.

HOPE THIS HELPS

check the switches mounted on the unit

Your best bet is to look up a local Liftmaster dealer in the yellow pages. They will be glad to help you.

ok... got it " LiftMaster Professional Model # 2575". Is this correct...?

Kindly wait & I will post back here again...

Regards,
micro