Sanyo Answered Questions & Fixed Issues

try unplugging thermistor if gets cold replace it if no bad compressor or low freon

Try this. Press and hold the {MUTE} button on the remote control while plugging the power cable back into the outlet. Keep pressing the {MUTE} button until the TV powers on with the Service Menu displayed. Use the {CH+} {CH-} buttons to select menus. If this doesn’t work for you, ask for more answers and include the model number of the Sanyo.

Select menu and then settings!

Power supply issue or overheating. Take it in for service and diagnostics.

There is no reset button on televisions. I see that is a plasma set, if you are just losing the picture that is one thing, if the whole set is shutting down, that is another. Please advise

They are normally repairable. V3 is just an update.

Answers should be down here! --- Anonymous Jan 15, 2021 It's not easy. I've had mine apart, and the soldered on battery is between the main board, and the soldered on display board, so you'd have to de-solder the display board just to get at the soldered on battery. Another approach would be to solder on some wires to a new battery back if you knew the voltage (3.3?). Mine works well enough with the clock always wrong. --- My 2 cents. Batteries have to show voltage and the capacity in MAH. This is often hidden under shrink wrap. The battery will be rechargeable, so you can measure the voltage going to it. charge voltage is a little higher, say 3.2 volts on a 3 volt battery.

Take the old battery out and replace it with a new identicle battery.

Switching of Projector within few seconds ??!! This problem is common when Projector lamp is not replaced with that of the same band & model but one can fool the projector lamp as it powered with logic switching ...0 V or 5 V set by its company ... Go through following Web : http://www.diy-community.de/forumdisplay.php?f=60 http://www.allinbox.com/modding.htm http://www.dity.nl/forum/lampen/442-...qi-lampen.html http://recklessphilosophers.com/2008...ad-of-300.aspx

Applicable codes would be found in a compatible remote control.

I don't think that type of phone uses a Sim card. It uses a separate network system used by some commercial businesses.

Excellent, it's a good set! https://www.google.com/search?q=Sanyo+FW43D25F ..

Page 59 of the manual refers https://www.cncms.com.au/SANYO-IMs/Consumer-Electronics/vpce2100exbk_im.pdf ..

@Greedy Girls Catering Is this it. https://www.ptacunits.com/product/0130p00116-power-cord-20a-230v https://www.google.com/search?safe=off&rlz=1C1QJDB_enCA643CA644&sxsrf=ALeKk02ibz4T0mJLYTTaukFBQbyKcEePQA%3A1609182138156&ei=uivqX8CWCcjctQbA-JKADg&q=sanyo+unit+stw1223c2p+power+lead ..

Would you like to sell me the power cord

Unplug your Cable or Satellite decoder. Does the message go away?

Use code search on your Sanyo URC to find something that works. If a search through all codes stored in the URC fails, try a different one.

You need to do a search for active channels in your area. For this, you will need a compatible remote control.

broken remote functions.. take apart and put back together. if that doesnt work. consider a universal remote with all of the same functions

If you look on the remote manufacturers web site, your tv should be listed or similar.