Sander Air Tools & Compressors - Recent Questions, Troubleshooting & Support

no, oil per instructions that came with sander.

If an automatic oiler system is not used, add a few drops of Pneumatic Tool Oil to the airline connection before operation. Add a few more drops after each hour of continual use. buy oil at HF where you bought sander, or HD, lowes. https://www.manualowl.com/m/Harbor%20Freight%20Tools/280/Manual/429462?page=1#manual

Part 15 https://www.toolpartsdirect.com/ingersollrand-311a-heavy-duty-air-dual-action-quiet-sander-6-pad.html

Go to an Auto Body Supply House or use the
internet to find parts

center gear to dots end gears roll all the back towards end of sander and move back 4 teeth

I work in a wood working shop and we use orbitals on everything. You still will still sand with nice even strokes with the grain. It leaves a great finish. They are nice, light, and easy to use! They do use a lot of air though, so make sure your air compressor can handle the one you buy. If you compressor is constantly running you might have to take breaks so you do not burn it up. enjoy!

http://www0.shopping.com/xFS?KW=sander+machine+oil&CLT=SCH

how to solve the this alaram what is the reason getting this alaram ,how to fault finding

Not being sure about this model but do you have the air hose connected to the tire vent and does it meet the minimum requirements? This may be the only way that the compressor can know how much pressure is in the tire and to start counting.

I have not been able to purchase replacement parts for these nail guns , however, have repaired them using parts from Bostitch framers and or just make the part. If the seal fits over the top of the cylinder, then try using seal from Bostitch framer part #N70155 fits a bit tight but works. Heat with a hair dryer to soften and install. If the seat is incorporated within the head valve, just dig it out and replace it with liquid two part urethane. Just mix and pour it in. After cleaning out the old seal, place head valve on level surface and pour in the mixed urethane till slightly over full to give the seal a nice crown. The finish nailer might also be repaired using other brand of seals. Remove the old part and take it to service center for a possible match. Good luck with your repair.

Change of Pressure sensor. Or Recalibrating is required.

Many air compressors use a mineral blend or a synthetic oil, such as synthetic hydrocarbon, polyol ester or polyglycol. It is important to use a lubricant specifically rated for air compressors; do not use a general-purpose motor oil used for automotive or other purposes. Read your user manual for more information.

You cannot. It is a hand operated staple gun.

It has a pressure valve that can give trouble if moisture enters in damp conditions but no restart button.

95851 comes up as a scissor jack. Please check your descrition and try again.

Firstly I would check the oil level and then use clean fuel and filters.