Ryobi Drills - Page 6 - Recent Questions, Troubleshooting & Support
Red light in charger flash when battery is put in
This behavior is typical of trying to charge a battery that is wither too hot (let it rest for a hour) or one that has done its job and is ready for the battery retirement home. Replace your battery for best results with your Ryobi battery powered tool.
Does it harm a Ryobi 18v lithium battery to leave on Charger?
Lithium-Ion batteries require careful charging and temperature monitoring while in the charger. Ryobi's Charging station monitors many functions and shuts off when the battery has gone through a complete charge. This is indicated by a steady Green light. Once the Charge indicator is a steady green the charger stops charging. With any battery It will slowly discharge and I don’t think the Ryobi will maintain a battery that is never removed. For example, if after a complete charge cycle if the battery was left there for 2 years and then you went to use it, it would likely be completely discharged. However if the battery charger is unplugged then plugged back in a new charge sequence would start. I lose power at my house about every 6 months or so. Once power is restored a new cycle would start and the charging cycle begins again.
Hope this helps and have a great day.
Ryobi Li-ion strimmer
check that you are using the correct line in the head
if it is too thick , the load will be causing the thermo switch for the motor to stop operation until it cools down
6/16/2017 6:13:04 AM •
Ryobi Drills
•
Answered
on Jun 16, 2017
My Ryobi PD750 impact drill just stopped working! Is there a safety button or something that could prevent it from working? Ive tried other plugs. Its fairly new.
The wires on the brushes sometimes shake loose , tool repair shop ,, or try it yourself ,, remember. Small parts ,, take pictures , tiny wires , may need to be soldered back in place ...
6/11/2017 5:38:16 PM •
Ryobi Drills
•
Answered
on Jun 11, 2017
Not finding what you are looking for?