Rotel Logo

Rotel Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 40 Products
  • 134 Answers
  • 18K Views

if it doesnt read any kind of dvd discs at all it only means you have been rip off. It happened to my sony dvd player that I bought from this website. I tested it and it only reads cd or audio cd. Good thing my couzin fixes electronics, He checked on the lens and it turned out that the lens has been replaced with an audio/cd lens like the one we use for our car stereo. Too bad!!!

Rotel RDV-1040... | Answered on Mar 24, 2010


The stylus should not be a problem. Without knowing the make and model of the turntable, however, there is no way to respond about hte arm. You have listed this question under the Rotel receiver category, can you pelase supply the ,ake and model of the turntable? Also, supply any numbers that appear on the current stylus so I can verify that either the exact one or a similar substitute is available.

Thanks,
Dan

Rotel Audio... | Answered on Nov 18, 2009


All I can say to you is look around where the mains goes in very carefully. Fuses are sometimes hidden or in a case or cover of some kind. Sometimes amps use fuseable resistors. If the PC board is marked up look for resistors with "RF" or different indication to a normal resistor. Otherwise fuses will have "f" markings on the board. Remember the power supply part might be enclosed in a metal case with holes in it, so might be hard to spot fuses.

Rotel RMB-1095... | Answered on Nov 02, 2009


Hi.

Regarding first question, you will probably need to replace volume potentiometer, that is the part located behind the wheel.
Regarding replacement part , including remote you can contact Rotel.
A rebuilt remote is also available at the link below:
Rotel RX975 Replacement Remote Control

Rotel RX-975... | Answered on Oct 25, 2009


Some manufacturers allow you to set a max volume limit so you don't blow your ears off.  Check the users manual to see how to turn it off.
Also, have tech support install a new potentiometer for you.

Rotel RX-975... | Answered on Oct 25, 2009


I don't believe that Rotel service manuals are available outside of authorized service centers. Can you provide us with the problem that you have? Perhaps we can guide you through the repair.

Thanks,
Dan

Rotel Audio... | Answered on Sep 21, 2009


Lets try the simple stuff first. This whole problem could be caused by a dirty switch contact. Pick up some electronics cleaner from a local electronics shop and spray the switch (from the inside of the unit). Work the switch on/off a number of times then respray one more time. That should clean out any dirt that is there. Try the unit again and hopefully the problem is resolved. If not, then the switch itself may need to be replaced. When you get the cleaner, get one that contains a lubricant as well. This will help to prevent the problem from coming back again.

Dan

Rotel Audio... | Answered on Jun 22, 2009


some amps have a switch to bridge them rather than wiring a bridge meaning output is mono check to see if yours has this switch if you do simply put back to stereo

Rotel RMB-1095... | Answered on May 20, 2009


Why would it die from being in storage? Oxide or corrosion on contacts, volume potentiometer, Tape Monitor or other switch contacts.

Try manipulating all controls and switches throughout their ranges many times and see what happens.

Check the heaphone jack. If it works so does the right amplifier. While you're at it, insert the headphone jack multiple times to cycle its contacts, too.

Rotel RMB-1095... | Answered on May 18, 2009


The URC database should have codes for that unit. The software for programming the MX-900 has it. Which remote are you trying to program?

Rotel RX-950AX... | Answered on May 12, 2009


This sounds like there is a problem with the final output stage. Is this a new amp? Is it under warranty?

Dan

Rotel RMB-1095... | Answered on Oct 10, 2008


Make sure you connected your record player in the right inputs. Better try it to a line level auxilliary input that is sure to pass the volume control. hope this helps..

Rotel Audio... | Answered on Sep 25, 2008

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Rotel Experts

 Grubhead
Grubhead

Level 3 Expert

5683 Answers

The Knight
The Knight

Level 3 Expert

76036 Answers

Raj Patel

Level 3 Expert

1025 Answers

Are you a Rotel Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...