Roper washer top loader stopped working
if you have the users manual try reading it to find a way to reset the system, if the problem still presist you can purchase a new one here>>www.discountbargainprices.com
My Roper Washing machine is full of water and won't run.
The motor tries to run but the machine does not agitate or empty.
Few washing machines use a water pump driven by the main motor - most have a separate motor/pump assembly.
Clearly there is more wrong with your washer than is immediately obvious. Not sure what is meant by the motor "tries" to run - surely it either runs or it doesn't?
Perhaps you mean because the motor isn't running you can hear the buzzing noise some controllers produce?
I am guessing either the controller is faulty or the controller thinks the tub is empty because something has gone wrong with the water level switch and so refuses to switch on the pump..
Clearly somebody with suitable experience should take a look inside.
Roper whirlpool model 2314273-A
This sounds like a defrost drain problem. Behind the panel in the back of freezer is a heater that defrosts the evaporator and below that is a drain hole. They will occasionally get clogged or just freeze over Pour hot water down it until it thaws then check to see if the water drains normally. If it drains after thawing then get a small length regular electrical wire and twist one end around the heater. You should get enough to extend the other end 2 or 3in into the drain hole. Now when the heater turns on it will heat the wire and thaw any ice in the top of the drain.
If you can't get water to drain then there is something clogging the drain tube and you'll have to find a way to clear it. I use a steamer that has a small tip to build pressure and force the clog out. Hope this helps.
Not finding what you are looking for?