Rockford Fosgate Car Audio & Video - Recent Questions, Troubleshooting & Support


First off will the fastener turn ? If not try using a bit of wd-40 and letting it "soak" for a little while . Also be sure you are using a good proper sized Phillips screwdriver . If the fastener still won't turn try using a can of "computer duster " inverted so the liquid comes out , note this will be well below zero degrees , and freeze the screw head , then try turning . If the fastener is stripped and the ttol slips you will have to remove the amp cover and grip it with a pair of vise grips ,pliers or a flat blade screw driver .

Rockford Fosgate... | Answered on Sep 24, 2019


You are driving it too hard. If continued, the amp will go into protect mode to save you from yourself.

Rockford Fosgate... | Answered on Jun 12, 2019


Yes. Wire the two 2 Ohm speakers in series and connect them to one channel. Connect the 4 Ohm speaker into the other channel. This will give you a balanced 4 Ohm load on each channel.

Rockford Fosgate... | Answered on May 12, 2019


i have a punch 45 but i'm missing the speaker wire connector.... were do i go to get one...

Rockford Fosgate... | Answered on Feb 03, 2019


Please be more specific. RF doesn’t share schematics

Rockford Fosgate... | Answered on Feb 03, 2019


IF you are looking for a schematic diagram on the amp, you wont find it. IF you need the connection information you can look on their site, There is a repair video on that unit attached . Rockford Fosgate Car Stereo Amp Repair

Rockford Fosgate... | Answered on Jan 13, 2019


Sounds like you have a short to ground.
Are you familiar with a DVOM at all, and do you own one ? Have you any electronic experience ?

Rockford Fosgate... | Answered on Oct 23, 2018


Found an online owners manual for your Punch P500.2. This only covers installation and setting gains etc and doesn't have a circuit schematic repair diagram -
Rockford Fosgate Punch P500 2 Manuals

Rockford Fosgate... | Answered on Sep 10, 2018


you can take the yellow and red wire on deck clip and the brain clip together then do the same to the neg. black wires and hook all the of cords from uint to a 12 volt batt and press the power button

Rockford Fosgate... | Answered on Jun 08, 2018


The remote wire goes to the back of the radio to blue remote or pwr antena blue wire, solenoid? No idea ..Is the amp on all the time, the radio is suppose to turn it on and off..

Rockford Fosgate... | Answered on Mar 07, 2018


The transistors will have the part number on them. Post a photo of the devices needed. Are they missing or exploded to the point they are not legible?

Rockford Fosgate... | Answered on Feb 14, 2018

Not finding what you are looking for?
Rockford Fosgate Logo

1,232 questions posted

Ask a Question

Usually answered in minutes!

Top Rockford Fosgate Car Audio & Video Experts

seankane89

Level 1 Expert

54 Answers

Professor_V
Professor_V

Level 2 Expert

93 Answers

Mike Duncan
Mike Duncan

Level 2 Expert

219 Answers

Are you a Rockford Fosgate Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...