Robot Coupe Popular Questions, Answers, Tips & Manuals

Contact Robot Coupe direct with a view to having it replaced under warranty. https://www.robot-coupe.com/usa/en_US/contact ..

Left hand thread perhaps.

Wiring diagrams are in the back of the manuals after the parts lists.https://www.partstown.com/robot-coupe/blixer-3b/parts#id=mdptabmanuals..

Question edited for clarity 'Robo Coupe' is two words. Question moved from Cars and Trucks category. Just one video on seals. https://www.google.com/search?q=robot+coupe%2C+replace+motor+seal+bushing ..

Question moved to correct category. Page 17 onwards has the wiring diagrams https://www.webstaurantstore.com/documents/pdf/r502_r602_-_manual.pdf ..

you look for hidden screw perhaps under a label

Possible dry bearings, I would check with the manufacturer.

Obvious answer I'm sure, but you'll have to replace the speed controller

To add the pulse button to your Robot Coupe R101, you will need to purchase the R101 Plus switch and front panel. The replacement is relatively simple and can be done by following these steps:

1. Turn off and unplug the Robot Coupe R101.
2. Remove the screws that hold the top cover in place and lift off the cover.
3. Locate the control panel on the front of the machine and remove the screws that hold it in place.
4. Carefully remove the control panel and disconnect the wires from the old switch.
5. Install the new R101 Plus switch onto the control panel and connect the wires.
6. Replace the control panel onto the front of the machine and secure it in place with the screws.
7. Replace the top cover and secure it in place with the screws.

Once the new switch and front panel are installed, you will have the pulse button on your Robot Coupe R101.

Pour penetrating oil down the upper shaft if possible. Remove the allen scews from the base with 5/32 T handle wrench. Remove the round snap ring on the motor shaft. Use vise grips or channel lock to secure the shaft. Twist the blade off and inspect it. It most likely will need to be replaced as the key that slides on the shaft will have deteriorated.

Yes you will need to replace the machine.

You will need to find a "small appliance repair shop" in your area, most likely the main PCB has failed, it controls the motor. Check the yellow pages.

http://www.spareparts.usa.robot-coupe.com/index.php?idtf=419

the unit needs service, i mean oiled and greased, it rubbing metal to metal and you are going to burn up the unit

Afraid careful dissasembly the only way. And check if blade is bent of course. Good luck.

how old is you megamix. you had to be carful and pull it out.

might be the start switch in the motor and or a capacitor. it should turn fairly freely by hand, if not it could be a bad bearing/bushing.

I can not see the machine if reset button broken? it can be replaced if it is a fuse-able button ,

Sounds like the bush is either worn, or the shaft has got rusted.

First you drill out the plastic plugs to acess the torx screws holding the housing together. Remove 4 motor mounting screws to separate from shaft.