Robot coupe 350 faulty switch how to dismantle
take out the side grills, and then remove the 4 screws (torax) remove the rubber covers (4) 4 on the handle, and also remove the screws...two shell parts come apart, and voila, there is the swich...good luck
Remove pin & replace in work bowl
it takes two to do this. there are two holes on the bottom part of handle. find something strong to push them in. one person pushes them in and have other person with pliers pull on the plug that you need to remove to get to broken pin. after that...replacement is easy
Hello
I have a Robot coupe
4 screws are covered by caps in the handle area, everyone finds these but there are a further 4 screws found by removing the air vent grilles. The grilles are held in place along their shorter sides midway. Pop a fine screwdriver in at this point and the grille comes off.
Now, how do I get them screw caps off? They are a really tight fit and is not easy to get them out!
The caps are not meant to be reusable as they get destroyed on removal. You can get them out by screwing in a fine sharp screw into the centre of the plastic to create a handle. Then pull out the screw with pliers. The cap comes out on the end of the screw. Remove the cap from the screw and tidy it up. It will re-use but will have a small hole in it. Seal with silicone.
You can find the two links with diagrams that can help also
http://parts.robotcoupe.net/mp350.html
http://www.retrevo.com/d/ds/progress?doc=7b922e7e8fac85f23bff2caf3670b97f&rk=0.4313016050679867
The machine I have seems
Hi
you can actually check the relays on the circuit board to check if it
really does it part which serves as triggering device with other
accessories.Thsi might be the problem why yuor motor sometimes does not engage.You can open the panel circuit board and check both ends
using a MULTITESTER.You have to unplug first ac source.Check the
continuity of the relay using a TESTER setting it to OHMS value.Now if
the reading kicked off to its maximum it means relay is not working
anymore..Hope this helps.
Reply
Does any one know how to dismantle a blender mp
4 screws are covered by caps in the handle area, everyone finds these but there are a further 4 screws found by removing the air vent grilles. The grilles are held in place along their shorter sides midway. Pop a fine screwdriver in at this point and the grille comes off.
I need to open the
Hi, I have looked for a service manual, but cannot seem to find one.
However these are not that complicated, and if you are simply going to replace the cord, then i think you should be Ok without one?
Just open it up, and get a replacement cord, and reattach it exactly as it comes off, I think you will be Ok.
As you will see when you get inside there is not too much to them.
Not finding what you are looking for?