I purchased a Robot Coupe R101 and wanted to add the Pulse button. Do I just get a R101 Plus switch and front panel? How hard is the replacement?
Thanks
To add the pulse button to your Robot Coupe R101, you will need to purchase the R101 Plus switch and front panel. The replacement is relatively simple and can be done by following these steps:
- Turn off and unplug the Robot Coupe R101.
- Remove the screws that hold the top cover in place and lift off the cover.
- Locate the control panel on the front of the machine and remove the screws that hold it in place.
- Carefully remove the control panel and disconnect the wires from the old switch.
- Install the new R101 Plus switch onto the control panel and connect the wires.
- Replace the control panel onto the front of the machine and secure it in place with the screws.
- Replace the top cover and secure it in place with the screws.
Once the new switch and front panel are installed, you will have the pulse button on your Robot Coupe R101.
Braun 4169 disassembly procedure
4169 blender dismantling.
this device is not suitable to be dismantled but this is how I did it.
1 disconnect from the mains.
2 lever off operating lever button at opposite end to hinge
3 insert sharp screwdriver into gap by top lid at same side as cable entry and prise off
4 heat up the casing with an electric paint stripper, wear gardening gloves.
5 when the casing starts to get pliable, insert a driver into the gap above the operating button locating lip and prise away as far as you can
6 do this with the locating peg on the other side
7 work between the two until the whole thing comes apart
8 lever out the motor, it will slide out once loosened
9 wash out the blender drive shaft with boiling water and detergent
10 dry out the body and soak the inside with silicone oil
11 work the blender blade until it spins freely
12 clean everything up and push it all back together
13 if any parts are deformed with the heat gun reheat them to a pliable state and reform them as best you can
14 if it is all loose when its back together, glue the joints with superglue and spray with glue accelerator
15 test it and if it's no good chuck it in the bin and buy a new one
16 but mine works fine.
Robot coupe 3b wiring diagram
Wiring diagrams are in the back of the manuals after the parts lists.https://www.partstown.com/robot-coupe/blixer-3b/parts#id=mdptabmanuals..
Not finding what you are looking for?